ArbNation Join free

Chainsaw protective trousers and injury reduction: what the Finnish logger survey found

A 1983 Finnish survey of 1,200 loggers found that 27 percent of power saw operators reported a near-accident within the survey's 12-month window in which protective equipment prevented harmful mechanical contact. Leg protectors ranked third.

Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The study, the leaflet and the standard are described here as published. It is not training and does not teach the work.

The Finnish survey

Two researchers, Klen and Vayrynen, published The protective influence of logger's safety equipment in the Scandinavian Journal of Work, Environment and Health in 1983. They sent a postal questionnaire to a sample of 1,200 loggers. It asked about accidents and near-accidents, with attention to how protective devices behaved in each.

Twenty-seven percent of power saw operators reported a near-accident, in the year before the survey, in which personal protection or saw safety equipment prevented harmful mechanical contact. The workers estimated the absence from work would have averaged 15 workdays if the injury had not been prevented.

Findings of the 1983 survey as the authors report them
MeasureResult
Sample1,200 loggers, postal questionnaire
Operators reporting a prevented injury in the year before the survey27 percent
Estimated absence avoided per near-accident15 workdays on average
Near-accidents during limbing60 percent
Near-accidents during felling30 percent
Equipment that most often prevented injurySafety boots, then the safety helmet, then leg protectors
Chain stopped by protective paddingEvery other near-accident involving a chainsaw
Chain blocked by padding materialEvery sixth situation
Chain went through the protective equipment10 percent of near-accidents

These are reports by the workers themselves. The abstract gives no count of injuries and no rate. The study covers all protective equipment, not trousers alone, and leg protectors appear in the abstract only as the third item in the ranking.

Legwear in the HSE leaflet

The Health and Safety Executive leaflet INDG317 (rev2), Chainsaws at work, published 01/13, says protective clothing that meets the appropriate standard should give a consistent level of resistance to chainsaw cut-through. It adds that no protective equipment gives 100 percent protection against cutting by a hand-held chainsaw.

For legs, the leaflet lists protection to EN 381-5. It says all-round protection is recommended for arborists working in trees and for occasional users such as those in agriculture. For occasional users on even ground with little snagging risk, it allows protective gaiters to EN 381-9 with steel-toe-capped boots.

The leg protector standard

The Swedish Institute for Standards (SIS) lists SS-EN ISO 11393-2:2019, approved October 1, 2019. It adopts ISO 11393-2:2018, Protective clothing for users of hand-held chainsaws, Part 2, performance requirements and test methods for leg protectors. The edition replaces SS-EN 381-2 and SS-EN 381-5.

The SIS scope statement says the document sets performance requirements, test methods, design requirements, and identification and marking information for leg protectors that protect against cutting by hand-held chainsaws. The standard runs to 40 pages and is sold by SIS.

Credit: the journal abstract is licensed CC BY 4.0. The HSE material is Crown copyright, reproduced under the Open Government Licence v3.0.

Sources