Changing ground levels and fill near trees: what five extension services publish
Extension services in Maryland, Iowa, Indiana, South Carolina and Texas treat raising or lowering soil grade over tree roots as a leading cause of construction damage. Their fill-depth figures differ by soil and species.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
The extension pages are described here as published. It is not training and does not teach the work.
Why grade changes harm roots
The University of Maryland Extension says any addition or subtraction from the natural soil grade adversely affects trees and shrubs. Young plants sometimes adjust to minor changes, but older, well-established trees are very sensitive. Iowa State University Extension makes the same point and adds that raising or lowering the grade in a tree's root zone can be fatal.
Iowa State puts most tree roots in the top 12 to 18 inches of soil, because roots need oxygen. The root system often occupies an irregular area four to seven times larger than the crown spread. Maryland places most roots within the top three feet and most feeder roots within the top six inches.
Clemson's Home and Garden Information Center names the three main causes of tree death during construction as soil compaction, grade changes and root severing.
Raising the grade
Maryland says soil placed over roots hampers the exchange of oxygen and carbon dioxide, causing dieback, decline or death. Excess soil against the trunk keeps the area moist and increases decay of the lower trunk bark. Clay soils do the most harm because the particles sit close together and slow air and water movement. Layers of different texture, called lithologic discontinuity, also upset drainage, temperature and air exchange.
Iowa State adds that soil additions compact the soil and often raise the water table. Purdue Extension calls raising the grade one of the most common causes of decline in trees on construction sites. Texas A&M AgriLife describes fill over roots as reducing the oxygen supply.
Fill depths the pages print
The figures differ by soil type and species, and the pages do not agree on a single safe depth.
| Source | Figure for fill over roots |
|---|---|
| University of Maryland Extension | Three inches of soil is the maximum depth that can safely be added without special provisions, and less if the soil is high in clay. Decreased oxygen is a common problem with clayey additions of more than an inch. |
| Iowa State University Extension | Additions of six inches or less probably will not harm fill-tolerant trees, especially with loamy topsoil high in organic matter. As little as two inches of clay soil causes irreparable damage around any tree, particularly fill-intolerant trees. |
| Purdue Extension | Trees can decline and die with as little as one inch of clay-type soil added to the existing grade. |
Maryland sorts species into three groups. Sugar maple, beech, dogwood, oak, tulip tree, pines and spruce are very sensitive. Birch, hickory and hemlock are less sensitive. Elm, poplar, willow, planetree, pin oak and locust are least sensitive. Iowa State lists silver maple, eastern cottonwood, swamp white oak, river birch, red maple, black willow, green ash, Colorado spruce and catalpa as fill-tolerant. Its fill-intolerant list includes white fir, ironwood, red oak, white pine, linden, white oak, Scots pine, sugar maple and serviceberry.
Lowering the grade
Maryland says lowering the grade can be as serious as raising it, because small feeder roots in the upper soil are removed. The cut also exposes remaining feeder roots to heat or cold that may kill them. Iowa State adds that scraping soil away removes absorbing and transport roots and topsoil, and heavy equipment adds compaction.
Clemson takes a milder view of small cuts: removing one to two inches of soil normally will not affect a tree's growth, unless a great amount of the root zone is exposed or removed.
Symptoms and timing
Iowa State says symptoms develop over months to many years. Early signs are reduced growth, yellowing leaves, crown thinning, delayed bud break in spring, and early fall color and leaf drop. Twig dieback follows, often with epicormic shoots on the trunk and major limbs. Severe damage means dieback of large branches and whole sections of crown, and eventually death. The speed depends on the amount of change, species, age and the tree's earlier health.
Purdue says trees often do not die at once from construction damage and that symptoms can take several years. Maryland says that when distress becomes severe it is usually too late for recovery, even after the excess soil is removed. Mild cases may recover if excess soil over the roots is carefully removed.
Protective measures
Maryland names tree wells and perforated pipe systems to give roots oxygen where a grade must change, and a consultation with an arborist on specimen trees before construction. Clemson describes a tree well, an aeration system of pipe or tile, and gravel layers for deeper fill. It adds that if a fill has been in place long enough for a tree to show deterioration, little can be done.
Iowa State calls aeration systems for deep fill near the trunk expensive and not always successful, and says the most practical solution is often to remove trees facing significant root injury. Maryland names root collar excavation with an air spade as the arborist's procedure for clearing piled soil. Related pages are the guide to grade change and tree wells and the guide to root collar excavation.
Sources
- University of Maryland Extension, Grade Change Problems with Trees, updated February 28, 2023, read October 19, 2026
- Iowa State University Extension, Preventing Grade Change Damage to Trees, reviewed May 2022, read October 19, 2026
- Purdue Extension, Why Is My Tree Dying? FNR-FAQ-11-W, read October 19, 2026
- Clemson Home and Garden Information Center, Protecting Trees During Construction, read October 19, 2026
- Texas A&M AgriLife, EarthKind landscape: Protecting Trees, read October 19, 2026