ArbNation Join free

Chipper and grinder noise: action values and hearing protection duties

Great Britain sets noise action values of 80 and 85 dB(A) and a limit of 87 dB(A). NIOSH treats 85 dBA as hazardous. HSE leaves a machine's level to workplace measurement or maker data.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The Health and Safety Executive (HSE) enforces the Control of Noise at Work Regulations 2005 in Great Britain, and the National Institute for Occupational Safety and Health (NIOSH) publishes the United States recommended limit.

Great Britain: the three levels

The Noise Regulations came into force for all industry sectors on 6 April 2006, replacing the Noise at Work Regulations 1989. HSE states their aim: workers' hearing protected from excessive noise that could cause hearing loss or tinnitus, which is permanent ringing in the ears.

Noise levels in the Control of Noise at Work Regulations 2005
MeasureLower exposure action valueUpper exposure action valueExposure limit value
Daily or weekly personal noise exposure, LEP,d or LEP,w80 dB85 dB87 dB
Peak sound pressure, LCpeak135 dB137 dB140 dB

HSE's regulations page ties the levels to duties. At 80 dB(A) employers must assess the risk and give workers information and training. At 85 dB(A) they must provide hearing protection and hearing protection zones. The 87 dB(A) limit applies after taking account of any reduction from hearing protection, and workers must not be exposed above it.

The 2005 Regulations act at levels 5 dB(A) lower than the 1989 ones. They also require health surveillance, meaning hearing checks, for workers regularly exposed above 85 dB(A).

Hearing protectors under the Regulations

HSE's guide Noise at work: a brief guide to controlling the risks (INDG362) lists the employer duties. Protectors must be provided, and used fully and properly, when exposure exceeds the upper action values. Between the lower and upper values, protectors must be provided if workers ask. Hearing protection zones are areas where access is restricted and wearing protection is compulsory.

The guide says hearing protection should not replace controlling noise by technical and organisational means. It is issued where extra protection is needed above what noise control has achieved, or as a short-term measure.

The guide's selection points are a suitable protection factor that does not isolate the wearer, fit with other protective equipment such as hard hats, and CE-marked protectors. HSE also lists a duty to maintain protectors, including headband tension and the condition of seals, and a duty on workers to report defects.

Estimating a level for a machine

INDG362 asks for a reliable, representative estimate of each worker's daily exposure. The estimate comes from measurements in the workplace, similar workplaces or data from suppliers of machinery. It makes no allowance for hearing protection.

Machine makers carry a duty to provide noise information with the operating conditions under which it was measured. HSE cautions that such data is likely only a guide to personal exposure, because many factors affect the levels workers experience.

The guide gives rules of thumb for a noise problem. They include workers having to raise their voices to hold a conversation about 2 m apart, and powered tools in use for more than half an hour a day. It also names mobile machinery as a safety issue, since noise and protectors can mask warnings.

Health surveillance

INDG362 says health surveillance usually means hearing checks every year for the first two years of exposure, then every three years. A suitably trained person must carry them out. Details on checks are in hearing tests and hearing conservation programmes.

United States: NIOSH

NIOSH calls noise hazardous at 85 dBA or higher. Its recommended exposure limit is 85 dBA averaged over an eight-hour workday, and NIOSH says workers at or above it risk significant hearing loss over a working lifetime. It describes decibels as logarithmic: a sound 10 dB louder is ten times more intense.

NIOSH counts about 27 million United States workers exposed to hazardous noise each year, and about 22 million exposed to ototoxic chemicals. It states that workers exposed to either should have a yearly hearing test. Hearing loss is the third most common chronic physical condition among United States adults, after high blood pressure and arthritis.

Saw and machine noise figures are in saw noise and vibration values, and UK noise rules for tree work in noise from tree work in the UK.

Sources