ArbNation Join free

Climbing in the cold, wet and heat: effect on rope and gear as makers state (wet strength loss, ice, UV)

A wet or icy rope is less abrasion resistant and harder to control in a device, one rope maker's notice states. Makers and the ICoP also name UV, heat and chemicals. None of the four documents prints a wet strength percentage.

Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.

The facts on this page come from the Industry Code of Practice for Arboriculture: Tree Work at Height (ICoP, Edition 2, May 2020), a technical notice for a dynamic climbing rope, and two rope-care pages from a fibre rope maker. It is not training and does not teach the work.

Wet and ice

The climbing rope maker's technical notice, written for an EN 892 dynamic rope whose principal material is nylon, has a line headed ice and moisture. A wet or icy rope is less abrasion resistant, and it is also harder to control in belay and rappel devices. The notice's pictogram section adds that wet conditions such as rain, sea spray or condensation, combined with cold weather below 0 degrees C, may affect the proper functioning of the product.

The same notice says an exceptional event can lead to a product being retired after one use, depending on factors that include extreme temperatures and chemicals. It gives a lifespan of 10 years for the rope and says a rope swells with use and can shrink in length by up to 10 percent.

UV, heat and chemicals

The ICoP lists points to weigh when selecting equipment, and two bear on weather. One is resistance to UV degradation, chemical contact, abrasive surfaces and resin or sap. The other is environmental exposure: extremes of heat and cold, tolerance to wet, dry or dirty conditions, poor storage and lack of maintenance. Under clause 3.10.6.8, friction hitch cord must be made of materials suitably resistant to the abrasion and temperatures met during work and rescue.

The fibre rope maker's care page says fiber rope begins to suffer some level of degradation as it is exposed to service conditions, among them temperature and chemical exposure. Glossy or glazed areas, changes in texture and stiffness are listed as signs that a rope has met raised temperatures, embedded grit or shock loading, with a possible loss of strength. Strength lost to abrasion or flexing tracks the amount of broken fibre in the rope's cross-section.

The maker's cleaning page puts nylon, polyester and olefin fibres as usually resistant to alcohol, greases and oils but poor against acids. It calls UV exposure harmful to the fibre and lists avoiding direct sunlight when drying. A 70 percent alcohol solution for disinfecting, held for 2 to 3 minutes at room temperature, can reduce fibre tenacity for some ropes, so the number of times it is applied over a rope's life should be limited.

Storage and weather limits

ICoP clause 3.11.5 sets storage in a chemically neutral, dry and dark environment, away from extremes of heat, sharp edges, corrosive substances and rodents. All equipment is dried before storage to prevent corrosion and fungal attack, particularly of textiles. The rope maker's notice states that failure to store a product properly can cause premature aging.

For crane-assisted access, ICoP clause 3.8.4.2 names conditions in which people should not be raised or lowered. They are winds above 7 m/s (25 km/h), thunderstorms, snow, sleet or ice, and fog. Any other weather that could affect the safety of personnel is also named.

Gaps in the sources

No maker page opened gives a figure for strength lost when a rope is wet or frozen. The sources do not set polyester against nylon on wet performance either: the fibre rope maker's cleaning page groups them together for chemical resistance.

Sources