ArbNation Join free

Climbing gear recall notice: Petzl ZIGZAG 2013 stop-use and the February 2014 Irish safety alert

The Health and Safety Authority of Ireland posted a safety alert in February 2014 on the recall of the original Petzl ZIGZAG mechanical Prusik. The maker found the rope end attachment can fail if set up incorrectly and recalled all units.

Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here.

The Irish alert

The Health and Safety Authority of Ireland titled its alert "Safety Alert regarding Petzl ZIGZAG Recall" and dated it February 2014. The Authority had been made aware of the recall of the original ZIGZAG mechanical Prusik, serial number 13108 followed by further digits, sold to arborists. The device lets the user move in the tree with a Prusik pulley system.

The alert records that the maker had learned of incidents involving the product and carried out a full recall. The maker's investigation found that the rope end attachment can fail if it is incorrectly set up, leading to a possible fall from height. The maker believed the incorrect set up could happen inadvertently, with serious and fatal consequences. It concluded that continued use of the ZIGZAG poses a risk of serious injury or death and recalled all units in the field.

The Authority advised owners of a unit with that serial number to stop using it and to contact the distributor's customer services team. The alert prints a UK telephone number for the distributor. It carries no separate notice number on the page.

The competition notices

The rules and technical committees of the ISA International Tree Climbing Championships post safety warnings and advisories. Its 2013 section includes an entry titled "Petzl Stop Use Notification for the Petzl ZIGZAG mechanical prusik", with the date shown as unavailable. The 2014 section carries an entry titled "Update from Petzl regarding possible presence of crack in ZIGZAG and ZILLON", also with the date unavailable.

In August 2021 the committees posted a Petzl safety warning for the ZIGZAG, ZIGZAG PLUS and the ZILLION, the spelling used on that page. Owners of affected devices must test them as described, and devices that fail the test at an ITCC gear check are quarantined. Health Canada and Petzl records of that later warning are in the 2021 recall entry.

The certification

Petzl's technical page on the certification of the ZIGZAG says the device carries the CE mark under Regulation 2016/425 with reference to the relevant articles of EN 12841:2006, the standard for rope adjustment devices. Petzl states that no rule applies exactly to a device like the ZIGZAG, and that EN 12841 is the closest. The functions match both type B, a rope clamp, and type C, a descender, so the certification body took the most relevant tests of both types.

The tests were run on two EN 1891 type A ropes of 11.5 mm and 13 mm, the smallest and largest diameters marked on the device. Petzl lists these ZIGZAG tests:

  • Locking within 300 mm after conditioning in damp, heat at +50 degrees C and cold at -30 degrees C.
  • A dynamic test dropping a 140 kg mass from 1 m onto 1 m of rope plus 1 m of dynamic lanyard, with the load held.
  • Descent speed reduced below 2 m/s in tests at 100 kg and 140 kg.
  • Parts touching the user heating to 48 degrees C at most.
  • Static tests between attachment holes and on the rope, with 12 kN required and 15 kN applied for the ZIGZAG.

Certification tests are done by the independent laboratory of the notified body that issued the EU type examination certificate.

To correct or remove an entry, write to the address at the foot of this page.

Sources