ArbNation Join free

Crane operator rules in England, Scotland and Wales

One set of regulations covers cranes in all three nations: the Lifting Operations and Lifting Equipment Regulations 1998, which apply in Great Britain. They set planning, supervision, marking and examination duties but name no operator licence.

Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The rules come from the Lifting Operations and Lifting Equipment Regulations 1998 (SI 1998 No. 2307, "LOLER"). The guidance comes from HSE code L113, HSE's forestry page and the BSI entry for BS 7121-1:2016. The national picture is in cranes in tree work.

Where the regulations apply

Regulation 3(1) of LOLER says the regulations apply in Great Britain, and outside it as sections 1 to 59 and 80 to 82 of the Health and Safety at Work etc. Act 1974 apply under the 1995 Order. England, Scotland and Wales are all in Great Britain, so one text covers the three. The regulations came into force on 5 December 1998.

Regulation 3 puts the employer's duties on three groups. They are an employer, for equipment its employees use; a relevant self-employed person, for equipment used at work; and a person in control of the equipment or of its users, to the extent of that control. Regulation 3(5) leaves out a person who only supplies equipment by sale, agreement for sale or hire-purchase.

The duties in the regulations

RegulationSubjectWhat the text says
4Strength and stabilityLifting equipment must be of adequate strength and stability for each load, with attention to the stress at its mounting or fixing point. Every part of the load and anything attached to it for lifting must be of adequate strength.
5Lifting peopleEquipment for lifting people must prevent crushing, trapping, striking or falling from the carrier, and must have devices to prevent the carrier falling. Where that risk cannot be prevented, the suspension rope or chain has an enhanced safety coefficient and a competent person inspects it every working day.
6Positioning and installationEquipment must be positioned so that the risk of the equipment or load striking a person, and of a load drifting, falling freely or being released unintentionally, is as low as reasonably practicable.
7MarkingMachinery and accessories for lifting carry a clear mark of their safe working loads. Where the safe working load depends on the configuration, it is marked for each configuration, or the information is kept with the machine.
8Organisation of lifting operationsEvery lifting operation involving lifting equipment must be properly planned by a competent person, appropriately supervised and carried out in a safe manner.
9Thorough examination and inspectionExamination before first use and after installation or reassembly at a new site. Then, for equipment exposed to conditions causing deterioration liable to result in dangerous situations: at least every 6 months for equipment lifting people and for accessories for lifting, and at least every 12 months for other equipment. An examination scheme can replace those intervals, and exceptional circumstances call for another examination.
10Reports and defectsThe examiner notifies the employer of any defect that is or could become a danger and reports in writing. A copy goes to the enforcing authority where the defect involves an existing or imminent risk of serious personal injury.
11Keeping of informationDeclarations of conformity are kept while the equipment is operated. Examination reports are kept for set periods; for an accessory for lifting, two years after the report is made.

Competent persons and operators

The regulations name a competent person for planning a lifting operation and for thorough examination. They define "load" to include a person. They define an "accessory for lifting" as work lifting equipment for attaching loads to machinery for lifting. LOLER sets no operator licence, ticket or age limit; the word operator does not appear in regulations 4 to 11.

Regulation 9(4) bars equipment from leaving an undertaking, or from being used in an undertaking that obtained it from another, without physical evidence of the last thorough examination.

The approved code of practice

HSE publishes L113, "Safe use of lifting equipment", as the approved code of practice and guidance for LOLER, second edition, December 2014, with amendments in 2018. HSE describes it as setting out what to do to comply with the regulations. LOLER builds on the Provision and Use of Work Equipment Regulations (PUWER). The 2014 edition expanded its examples to show that LOLER applies across every sector that uses lifting equipment.

HSE on lifting equipment in forestry

HSE's forestry page says lifting operations should be properly planned, appropriately supervised and carried out in a safe manner. It adds that people planning a lifting operation need adequate practical and theoretical knowledge and experience of planning similar operations. Work is organised so that, where practicable, loads are not carried or suspended over people.

To reduce the risk of collapse or overturning, HSE lists stabilising equipment such as outriggers, correct tyre pressure, level ground for cable crane winch units and firm, level areas for timber stacks. Lifting equipment used to lift loads needs a thorough examination by a competent person. Between examinations PUWER requires inspection and maintenance at suitable intervals, which HSE bases on risk assessment and the manufacturer's instructions.

BS 7121-1

BSI lists BS 7121-1:2016, "Code of practice for safe use of cranes: General", published 31 January 2016. BSI describes it as recommendations for cranes permanently or temporarily installed in a work environment, and as guidance on meeting LOLER and PUWER. Its contents include safe systems of work, erection and dismantling, maintenance, inspection, thorough examination, operation, and planning and management. BSI adds that HSE and the courts use it as an indication of good practice. BSI marks the standard "Current, Under Review".

Sources