ArbNation Join free

Espalier, cordon and step-over fruit trees: forms and the trees that suit them

The RHS describes the espalier as three to five pairs of horizontal arms, the cordon as one stem at 45 degrees or upright, and the stepover as a 45 to 60 cm trunk with one or two horizontal arms.

Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.

The Royal Horticultural Society (RHS) and Oregon State University Extension publish the trained fruit tree forms described below, with the supports, the trees and the pruning dates each needs. This is a description of what they publish. It is not training and does not teach the work.

The three forms

Trained forms on the RHS apple and pear pages
FormShapeSize the RHS prints
EspalierOne vertical trunk with three to five pairs of horizontal branches, trained flat against a wall or fenceUsually three or four tiers, about 1.8 m (6 ft) tall and 3 to 4.5 m (10 to 14 1/2 ft) wide
Oblique cordonOne stem at 45 degrees with short fruiting side-shoots called spursUsually kept 1.5 to 2 m (5 to 6 1/2 ft) tall; planted 60 to 90 cm apart
Vertical cordonOne stem, or two (U cordon) or four (double-U), held uprightOne stem can pass 3 m (10 ft) unpruned; can be kept at 2.4 m (8 ft) or less; planted at least 60 cm apart
StepoverShort trunk with a pair of horizontal arms in a T, or one armTrunk 45 to 60 cm (18 to 24 in); two arms span up to 3 to 3.5 m; one arm usually 1.5 to 1.8 m

The RHS says cordons suit a small space, a container or a collection of several cultivars, and can sit as close as 60 cm. It rates oblique cordons as usually more productive than vertical ones, because the 45 degree stem reduces the dominance of the topmost shoot. Vertical cordons tend to fruit slightly less well and are harder to keep in shape. Multi-stemmed U and double-U forms stay better balanced.

Trees that suit each form

The RHS pages share one rule for cordon and stepover: a spur-bearing cultivar grafted onto a dwarfing rootstock. Stepovers call for a very dwarfing rootstock. Spur-bearing cultivars carry fruit on short side-shoots. The RHS says tip-bearing cultivars are not suitable for either form and partial tip-bearers may be trained, though some are harder to maintain. Unless the cultivar is self-fertile, a compatible pollination partner is needed in the same or a neighbouring garden.

For pears the RHS names semi-dwarfing rootstocks as the best choice for cordons and stepovers. The RHS pages name two starting points: a one-year-old maiden to train from scratch, or a pre-trained tree. A pre-trained double-U cordon gives a head start of up to four years.

Supports

All three forms need permanent supports. The two bodies print different figures.

Support figures as printed
Source and formWire and post figures
RHS espalierHorizontal wires 35 to 45 cm (14 to 18 in) apart; first wire 40 cm (16 in) from the ground
RHS cordonThree wires 60 cm (2 ft) apart, lowest 30 cm (1 ft) from the ground; wire at least 10 cm from a wall or fence; posts 2 to 3.5 m apart; rows ideally north to south, oblique cordons leaning north
RHS stepoverPosts 1.5 to 3 m (5 to 10 ft) apart, slightly taller than the tree; one taut galvanised wire between posts
Oregon State espalierPosts 8 feet apart; 12-gauge or heavier galvanized wire; first wire 18 inches above the ground and usually three levels 18 inches apart

Oregon State adds that a trellis fixed to a wall may have to stay up for as long as 10 years, even though it can come off once the tree holds its shape. The RHS gives 2.5 mm (gauge 12) galvanised wire for cordons and stepovers. Oregon State gives 12-gauge or heavier.

Pruning dates and shapes

All three forms need annual summer pruning. The RHS puts it once the lower third of the new shoots has turned woody, from late July for pears and mid to late August for apples. Pruning earlier than that can bring regrowth, which the RHS says to cut back in September or October to one leaf past the earlier cut.

On established espaliers the RHS gives these cuts:

  • side-shoots from the horizontal branches cut to three or four leaves above the basal cluster;
  • side-shoots already pruned in earlier years cut to one leaf above the basal cluster;
  • overly vigorous upright shoots removed.

The RHS says an espalier left unpruned reverts to a tree shape with a dominant top tier. After seven or eight years, spurs may need thinning in winter. New tiers are made by pruning the central stem in winter to bring shoots, which are tied at 40 degrees and lowered to horizontal in late summer. The first tier is made from a one-year-old tree cut to 5 to 7 cm (2 to 3 in) above the first wire.

Cody Copp, an Oregon State University Extension horticulturist, says an espalier must be pruned several times in the growing season and is not less work than a regular tree. Oregon State has the tree planted in late winter, usually February, and spurs left about every 6 inches and cut to three leaves in the growing season. Fruit forms on them after two years, and spur renewal starts after about four years.

Sources