ArbNation Join free

Fire season restrictions for chainsaw use: California, British Columbia and Victoria

California ties portable saws to a shovel or extinguisher within 25 feet. British Columbia grades fire danger in five classes, and Victoria sets spark arrester, 3 metre and 9 litre conditions for saws.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. Three jurisdictions are covered: California's Public Resources Code, British Columbia's Wildfire Regulation and the Country Fire Authority (CFA) in Victoria, Australia.

California

Public Resources Code section 4431 covers any time of year when burning permits are required in an area. In that period the section bars using a portable saw, auger, drill, tamper or other gasoline-powered portable tool without a fire tool at the spot. It reaches tools used on or near forest-, brush- or grass-covered land, within 25 feet of flammable material. The fire tool is one serviceable round point shovel at least 46 inches long, or one serviceable fire extinguisher. The Director of Forestry and Fire Protection sets the extinguisher type and size by administrative regulation. The fire tool can be no more than 25 feet from where the saw works, with unrestricted access for the operator. The section was last updated on January 1, 1993.

Section 4442 is a separate rule on engines. It bars using any hydrocarbon-fueled internal combustion engine on forest-, brush- or grass-covered land unless it has a spark arrester in effective working order, or is built, equipped and maintained for fire prevention under section 4443. A spark arrester removes and retains carbon and other flammable particles over 0.0232 inch from the exhaust, or is qualified and rated by the U.S. Forest Service. It cannot be mounted so that exhaust flames or heat can ignite flammable material. Truck, bus and passenger vehicle engines with a Vehicle Code muffler, turbocharged engines that meet the section's conditions, and engines in permitted closed-course races are exempt.

British Columbia

The Wildfire Regulation, B.C. Reg. 38/2005, was last amended on April 20, 2026. It defines a "high risk activity" to include using fire- or spark-producing tools, including cutting tools. It also lists operating a power saw in a cutblock, outside a road, landing, roadside work area or log sort area. The regulation counts a risk of fire starting or spreading only when the ground is snow free and the daily fine fuel moisture code exceeds 75 or the duff moisture code exceeds 6.

Section 6(2) applies from March 1 up to November 1 to a high risk activity on or within 300 metres of forest or grass land, unless the area is snow covered. The person carrying it out determines the Fire Danger Class from the Danger Region, the Buildup Index and the Fire Weather Index. While a risk of fire exists, Schedule 3 sets the restriction for each class, and the site holds fire fighting hand tools for each worker, at least one each, plus an adequate fire suppression system.

Schedule 3 restrictions on high risk activities, B.C. Reg. 38/2005
Fire Danger ClassRestriction
I and IINone listed in Schedule 3
III (moderate)After 3 consecutive days of class III or greater, a fire watcher for at least one hour after the activity ends
IV (high)A fire watcher for at least 2 hours after the activity ends. After 3 consecutive days of class IV, the activity stops between 1 p.m. local time and sunset
V (extreme)The activity stops between 1 p.m. local time and sunset, with a fire watcher for at least 2 hours. After 3 consecutive days of class V, it stops all day

Section 8 covers engines on or within 300 metres of forest or grass land when a risk of fire exists. The engine needs precautions against causing a fire, a spark arrester that is an integral part of the exhaust system and in good repair, and an exhaust system and muffler within the maker's specifications. Section 34 sets a fine of up to CA$100,000, or up to one year in prison, or both, for breaking section 6(2), 6(3), 6(4) or 8. Breaking section 5, on hand tools for an industrial activity, carries a fine of up to CA$10,000.

Victoria, Australia

The CFA declares a Fire Danger Period by municipality when fire risk rises, and a Total Fire Ban on days when fires are likely to spread rapidly and be hard to control. Its "Can I or can't I?" page answers the chainsaw question for both. The CFA's August 2025 leaflet carries the same answers.

During a Fire Danger Period the answer is no, unless the chainsaw, plant or grass trimmer or lawn mower meets four conditions when used in vegetation that is not green:

  • It is free from faults and mechanical defects that could cause an outbreak of fire.
  • It has an efficient spark arrester.
  • An area of at least 3 metres around the machine is clear of flammable material.
  • A person is in attendance at all times, with a knapsack spray pump or a stored-pressure water extinguisher, each in working order, fully charged and of at least 9 litres.

The spark arrester, pump and extinguisher must comply with the applicable Australian Standards. Work in green vegetation is permitted, though the CFA suggests the same equipment and precautions.

On Total Fire Ban days the CFA says chainsaw use should be avoided wherever possible, because the risk of starting fires is extremely high. If the work cannot be avoided, the same conditions apply. The CFA's separate hot-work row bans welding, gas cutting, soldering, grinding, charring and power-operated abrasive cutting discs on those days, and says the CFA, DEECA or FRV may issue a permit in limited circumstances. In a Fire Danger Period the hot-work answer is no unless there is a fire-resistant shield, a cleared radius of at least 1.5 metres, and a hose or 9 litre water knapsack to hand.

Sources