FISA 302 basic felling and manual takedown: what the guide covers
FISA 302 is the Forest Industry Safety Accord guide to basic chainsaw felling and manual takedown. Paragraphs 24 to 34 cover the hung-up tree.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
The named codes and training bodies are described here as published. It is not training and does not teach the work.
Scope of the guide
The Forest Industry Safety Accord (FISA) lists FISA 302 as "Basic chainsaw felling and manual takedown", updated June 2018. FISA calls it a set of industry agreed safe working practices for felling and taking down trees with a chainsaw. It sits in the 300s, the series FISA reserves for chainsaw use.
The guide leaves out two kinds of work. One is trees too small to take a sink cut. The other is any felling where wire cable, rope or machinery directs or assists the fall. Work outside that scope calls for competent advice and a revised, site-specific risk assessment. The Forest Works Manager or the person in control of the works authorises it.
The Health and Safety Authority in Ireland publishes the same guide as IFSG 302, dated 2018. Its summary sets a tighter scope: plantations, or single trees in open spaces with at least two tree lengths of clear space in every direction, where pulling aids are not required.
Who the guide is for
The guide names operators, landowners, managers and supervisors as its readers. It says they must be adequately trained and experienced. FISA also lists three uses: judging a safe system of work, checking compliance with risk assessments and method statements, and finding training needs. The leaflet doubles as a checklist, with a verification block for a name, a checker and a date.
FISA 302 was produced with the Arboricultural Association. It describes itself as evidence of good practice for a specific forestry task. Departing from it should follow a full risk assessment by competent persons, and health and safety obligations still apply in every case. It points to FISA 301 for personal protective equipment, the saw, fuelling and starting.
Contents by paragraph
| Section | Paragraphs | Topics named in the guide |
|---|---|---|
| Risk assessment and tools | 1 | Aid tools such as a breaking bar, a sledgehammer, wedges, a hydraulic toe jack and a hand winch. Radios or phones for contact with a named person on site. |
| Preparing to fell | 2 to 13 | Safe working distance, underground and overhead services, wind, escape route, clearing the base, brashing and tree condition. |
| Felling | 14 to 23 | Sink cut, main felling cut, hinge, rot, buttresses, a trapped saw, levering the tree over and the move into the escape route. |
| Takedown of hung up tree | 24 to 34 | Risk assessment, a list of things not to do, rolling and levering, a hand winch, exclusion zones and machine help. |
Distances and cuts in the guide
FISA 302 calls tree felling a one-person operation. It keeps a safe working distance of two tree lengths unless exceptional conditions and a thorough risk assessment point elsewhere. Near overhead power lines it sets a clearance of not less than twice the height of the trees. Within two tree lengths of the lines, it calls for advice from the line owner. FISA Leaflet 804 holds the detail.
The felling paragraphs ask for a sink cut every time. The two cuts of the sink align to the felling direction and meet exactly so the hinge is not weakened. The main felling cut goes at or slightly above the level of the horizontal sink cut. A parallel-sided hinge at right angles to the direction of fall gives directional control.
Once any felling cut starts, the guide says the tree must not be left standing, and no new operation begins until it has fallen. As the tree starts to fall, the guide has the feller move at least 3 metres into the escape route where site conditions permit. It warns of the butt rebounding and of the whole tree sliding on a slope.
For work out of sight of colleagues, the guide describes radio or phone contact and an agreed check-in time, for example every 20 minutes. If contact is lost, chainsaw work stops until contact or sight is restored.
The hung-up tree, paragraphs 24 to 34
Paragraph 24 starts with a risk assessment as soon as a tree lodges. It asks whether the tree can be dealt with immediately, safely and effectively with the equipment on hand. Paragraph 25 then lists six things the guide says not to do:
- fell the supporting tree to free the hung-up tree
- fell another tree across the hung-up tree
- climb the hung-up tree
- walk or work under it
- cut product-length pieces off the butt end, with very short lengths allowed to move the tree past a local obstacle
- leave it unattended, or, if that cannot be avoided, tape off the danger area and tell others on site and the Forest Works Manager
Paragraphs 26 and 27 deal with the assessment of the danger areas and breakages in the supporting tree. They put nobody within two tree lengths, or directly below on steep ground. On slopes they place escape routes on the uphill side wherever possible.
Paragraphs 28 to 31 cover removing the hinge from a position at the side of the tree and rolling a lodged tree with a felling lever and cant hook. The guide specifies a pushing movement: a pull brings the tree toward the operator.
Paragraph 32 covers a hand winch. The estimated weight of the tree must be within the winch capacity, and nobody stands in the danger area between the winch anchor, the offset point and the target tree. FISA 310 holds the detail of winch use.
Paragraph 33 covers a tree that manual techniques cannot bring down. The guide has the crew set exclusion zones and work elsewhere until equipment arrives. It adds that the tree should be dealt with as soon as practicable, and that third-party access may need extra measures.
Paragraph 34 covers working with a machine. The guide puts the decision on whether the tree's estimated weight is within the machine's capability with the machine operator, not the chainsaw operator. The two operators decide the system for severing the hinge together. They agree a sequence of events, communication systems (voice preferred, hand signals if agreed in advance) and escape routes.
Related publications
The Health and Safety Executive lists its Arboriculture and Forestry Advisory Group (AFAG) publications on one page, and forestry-based AFAG leaflets are held on the FISA website. FISA keeps the 302 listing and its PDF on its safety guides page. For the winch leaflet, see FISA 310 on winches in directional felling and takedown.
Sources
- Forest Industry Safety Accord, FISA 302 Basic chainsaw felling and manual takedown, guide page, read October 19, 2026
- Forest Industry Safety Accord, FISA Safety Guide 302 Basic chainsaw felling and manual takedown, PDF updated June 2018, read October 19, 2026
- Health and Safety Authority (Ireland), Felling and Manual Takedown IFSG 302, 2018, read October 19, 2026
- Health and Safety Executive, Arboriculture and Forestry Advisory Group publications, read October 19, 2026