ArbNation Join free

Herbicide labels for trees and stumps: registers and what extension reports

Three government registers hold pesticide labels and registrations, herbicides among them. A Florida extension bulletin lists active ingredients its authors name for cut-stump, basal bark and hack-and-squirt work.

Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.

The US, British and Australian registers and one extension bulletin are described here as published. It is not training and does not teach the work. The EPA page opens with a reminder to read the pesticide label. The bulletin says most hack-and-squirt labels specify 0.5 to 1.0 ml of solution per hack, and the label gives the hack spacing.

Three registers

The US Environmental Protection Agency keeps a Pesticide Labels page. It links to an introduction to labels, a page on finding labels, the Label Review Manual and pages on web-distributed labels. The page was last updated on September 14, 2026.

The Health and Safety Executive runs the Pesticides Register for Great Britain and Northern Ireland. Its search page covers plant protection products with an authorisation. Fields include product, active substance, crop, extent of authorisation, amateur or professional use, aquatic use, aerial use and LERAP category. Field of use includes a Herbicide choice.

In Australia the APVMA publishes PubCRIS, the Public Chemical Registration Information System. Searches run on product name, registrant, active constituent, pest and host, and advanced search adds product type (herbicide is one), registered state, poison schedule and formulation type. PubCRIS notes that active constituent approvals have no expiry date, product registration end dates are updated each July, and a container label approval is renewed when the product registration is renewed.

Cut-stump, basal bark and hack-and-squirt

A University of Florida (UF/IFAS) bulletin, first published in January 2006 and revised in December 2015 and December 2024, describes the three methods for pastures, fencerows and rights-of-way. Its authors name these among the active ingredients for each method.

Methods and active ingredients named in the UF/IFAS bulletin
MethodActive ingredients and rates named
Cut stumpImazapyr; triclopyr amine at 50 to 100 percent in water; triclopyr ester at 25 percent in water or basal oil; glyphosate at 50 to 100 percent
Basal barkImazapyr at 8 to 12 oz per gal for trees under 4 inches DBH; triclopyr ester at 25 percent in 75 percent basal oil for trees under 6 inches DBH
Hack-and-squirtImazapyr at 6 oz per gal; triclopyr amine at 50 to 100 percent; glyphosate at 50 percent

For cut stumps the bulletin says the herbicide goes on the cut surface as quickly as possible after the sawdust is removed. A water mix works if applied at once. A stump that has begun to dry needs an oil mix. On stumps over 3 inches across, the bulletin says only the outer edge is living tissue and needs wetting. It adds that glyphosate does not work on stumps that have started to dry.

Basal bark treatment mixes herbicide with an oil penetrant and covers the lower 12 to 18 inches of the stem on all sides. The bulletin says it is frequently successful on smooth-barked trees under 6 inches across and ineffective on older trees over 6 inches or on thick bark. Injury often shows only after several weeks and complete control can take several months.

For hack-and-squirt, the bulletin describes hacks cut through the bark into the sapwood at about 45 degrees downward to hold the solution. It adds that the method suits places where dead standing trees are acceptable, and it is not recommended along roadsides or in parks.

Minnesota's species notes

The Minnesota Department of Natural Resources lists cut-stump treatment with glyphosate, and cut-stump or basal bark treatment with triclopyr, among the chemical control methods for common buckthorn. For Russian olive it names glyphosate or triclopyr on the freshly cut stump, and an oil-based triclopyr ester sprayed on the lower 12 to 18 inches of an uncut stem.

Sources