ArbNation Join free

Log splitter injuries: what CPSC and workplace regulators record

Four US Consumer Product Safety Commission recall notices from 1991 to 2018 record log splitter hazards: auger entrapment with no stop control, detaching cylinder rods, a cracking tank mount and a moving arm under a carry handle.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

The US Consumer Product Safety Commission (CPSC) recall notices below describe the hazards and record injuries only as counts. No victims are named. No national injury figure is given. Machine types are described in the log splitter types guide.

Four CPSC notices

Log splitter hazards in CPSC recall notices
Notice and machineHazard in the noticeReports
April 24, 1991, recall 91-060. Auger-type splitters made 1977 to 1988, in engine, tractor and vehicle rear-wheel powered models. CPSC estimates about 8,000 units.Entrapment of hands, arms and legs, with a risk of serious injury or death. No operator accessible off/on switch, no dead-man feature, no guard on the auger.At least four serious injuries and one death. The injuries involved loss of arms, legs or fingers.
February 15, 2005, release 05-110. Hydraulic splitters in four sizes from 15 to 34 tons. About 4,000 units.Hydraulic cylinders can have defective rod retention, so the seals leak and the rods detach. The rod can rapidly and unexpectedly extend the splitting wedge.14 reports of leaking cylinders or rod retention failure. No injuries.
July 7, 2011, recall 11-273. 5-ton electric splitters. About 20,000 units.The moving hydraulic arm slides under the handle used to move the machine, a laceration or amputation hazard for hands placed on that handle during operation.Two injuries: a fingertip amputation and a finger laceration.
November 13, 2018, recall 19-715. 40-ton hydraulic splitters, model year 2018. About 1,460 units.Welding on the tongue box assembly can crack and let the tank separate from the unit, an injury hazard.Three reports of cracked welding. No injuries.

The 1991 auger notice

CPSC first learned of the hazard from a consumer complaint. The notice warns of serious injury or death from entrapment. It names three missing features: an operator accessible off/on switch, a dead-man feature to assure the auger stops if the operator loses control, and a guard on the auger.

The notice urges owners to make the unit unusable by unbolting, removing and discarding the auger tip assembly. The recall header lists the remedy as none available, so the notice reads differently in two places on that point.

Cylinder, handle and tank notices

The 2005 notice puts the hazard in the cylinder. Rod retention can fail, the seals leak and the rod detaches. CPSC lists the models by tonnage and serial range and notes the serial plate is on the hydraulic tank. It records no remedy, because the firm is no longer in business, and says the units should be destroyed.

The 2011 notice puts the hazard at the machine's carry handle. The notice reports that both injured people had placed their hands on the handle while the splitter was running. The remedy it names is a set of warning labels, classed as new instructions.

The 2018 notice records cracking welds on the tongue box, with three reports and no injuries. The remedy it names is a free replacement tongue box assembly, and the notice tells owners to stop using the splitters until it is fitted.

Gaps in the notices

Each notice counts reports tied to one product. None gives a national total of log splitter injuries. The hazards differ by notice: the earliest is a missing control, the others are a cylinder, a handle position and a tank mount. The 2021 log splitter recall has its own page, and so does the 2024 recall.

To correct or remove an entry, write to the address at the foot of this page.

Sources