ArbNation Join free

Log storage before milling: what FPL and extension say about stain, checking and insects

The Forest Products Laboratory manuals and a Western Australian timber note describe what stored sawlogs suffer: end checking, stain, decay fungi and insects. Their time figures run from two days to three months, and none sets one storage limit for all logs.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

The Forest Products Laboratory (FPL) Dry Kiln Operator's Manual, Agriculture Handbook 188, devotes a section of chapter 10 to log storage. Logs need storage that limits end checking, which comes from shrinkage, and attacks by fungi, bacteria and insects. The manual puts the best case in cloudy, wet, cold weather: shrinkage defects are minimal then, and fungi and insects are inactive below 32 degrees F. It prints no numeric limit on how long logs may wait, only that tree-length and standard-length logs should be sawed into lumber as soon as possible after felling, especially in warm weather.

Figures printed in the sources

Time and temperature figures for stored logs
ConditionFigureSource
Fungal blue stain on exposed ends and debarked surfaces in warm weatherWithin 2 weeks after fellingFPL Dry Kiln Operator's Manual
End stain under favourable conditionsMay appear within 2 weeks and travel into the log as fast as 1 ft per monthFPL Dry Kiln Operator's Manual, figure caption
Grey, blue or black sapstain in suitable warm, moist conditionsCan develop within 1 weekWestern Australia timber advisory note
Superficial white or green mouldsWithin 2 daysWestern Australia timber advisory note
Yellow-brown discolouration of decayAfter about 4 weeksWestern Australia timber advisory note
Time from felling to millingIdeally within 1 weekWestern Australia timber advisory note
Delay that may allow infection in Australian conditions, except winter in the southern states2 to 3 daysWestern Australia timber advisory note
Preservative sprays promptly applied protect most species in storage2 to 3 months, except in severe decay hazard climates such as MississippiFPL Wood Handbook, chapter 14

The Western Australian note adds temperature and moisture limits. It reports rapid fungal development at 24 degrees C and negligible development below 10 degrees C. Log moisture content above 20 percent is required for fungal growth. Heartwood is not usually affected, and susceptibility varies widely among species.

Dry storage with bark on

The FPL manual says most sawlogs in North America are stored on land with the bark intact. Drying problems then come from serious end checking, insect attack and sapwood stains. End checks occur in all species and show most in the denser hardwoods. Cool, moist, shaded log ends minimise them. Deep end splits from tree growth stresses cannot be prevented by these measures.

Brown stain and blue stain develop together in lumber from logs stored in the forest or in similar shade. The manual calls prompt sawing the easiest way to control chemical sapwood stains, because treating logs with fungicides that prevent blue stain will not be effective. It adds that wood-boring insects can carry spores and hyphae of staining fungi into the log through areas where bark is attached.

Debarked logs get separate treatment. Most logs for lumber are debarked on the day of sawing. The manual says logs for poles and pulpwood are debarked soon after felling to cut losses from borers and decay, at the cost of extensive surface checking, end splitting and stain.

Wet storage and water sprays

FPL describes wet storage as keeping logs soaking wet to prevent drying and checking and to inhibit insects and sapwood-stain fungi. Some bacteria are not inhibited, and the wood may become more prone to chemical stains. Pond storage is rare in North American mills. Lumber from logs submerged over a year is likely to develop honeycomb, ring failure and collapse.

Water sprinkling of log decks reduces checking, sapwood stains and decay when temperatures are above freezing. The manual says log ends and exposed surfaces must stay continuously wet for the whole storage period, and sprinkling gives no certain protection from insect attack. The Wood Handbook puts it the same way: for logs, rapid conversion into lumber or storage in water or under a water spray is the surest way to avoid fungal damage. The Western Australian note calls a properly run spray system extremely effective against fungal attack in hardwood and softwood logs, and notes that it also cuts end splitting and checking.

Stain and checking in the Wood Handbook

FPL's Wood Handbook, chapter 13, says unwanted discoloration can develop in the tree, during storage of logs and green lumber, or during drying. Microbial stains come from blue-stain fungi, mold or bacteria, mostly fungi growing in sapwood. Blue-stain fungi do not cause decay of the sapwood, the chapter adds. Chapter 14 says that for storage longer than the 2 to 3 months sprays protect, an end coating is needed to prevent seasoning checks through which infection can enter the log.

What none of the sources prints

No source sets a single safe storage time for sawlogs. The figures above depend on species, climate and method, and each source ties them to its own region.

Sources