Operator training units and tickets for machines: NZQA units and NPORS cards
New Zealand publishes unit standards for truck-mounted platforms and quad bikes, 23961 and 24561. In Great Britain the NPORS scheme issues operator cards across eight plant categories.
Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. The New Zealand Qualifications Authority (NZQA) publishes unit standards, and NPORS, the National Plant Operators Registration Scheme, publishes its card routes and plant categories.
Units and tickets by country and machine
| Country and machine | Unit or ticket | What the issuer records |
|---|---|---|
| New Zealand: truck-mounted EWP | NZQA unit standard 23961, version 4, level 3, 4 credits | Assess the worksite, prepare, and operate the platform, report faults and shut down. Prerequisite: unit 23966, describing EWP types and industry requirements, or equivalent knowledge and skills |
| New Zealand: quad bike with trailed equipment | NZQA unit standard 24561, version 4, level 3, 4 credits | Operate a quad bike with trailed equipment under limited supervision, in a primary industry setting. Prerequisite: unit 24554. Marked as an expiring unit standard |
| Great Britain: plant and machinery, all NPORS categories | NPORS operator card: Traditional, CSCS Trained Operator (red) or CSCS Competent Operator (blue) | Issued after training and testing with an NPORS accredited training provider; see the card table below |
New Zealand: unit 23961, truck-mounted EWP
NZQA lists unit 23961 under Cranes, in the power-operated platforms group. Version 4 dates from October 27, 2022, with a planned review date of December 31, 2027. Its guidance information ties the tasks to WorkSafe New Zealand's August 2014 guidelines for mobile operating work platforms, to AS 2550.10-2006 and to ISO 18878:2013 on operator training. A truck-mounted EWP is also called a vehicle mounted platform EWP.
Outcome 1 is worksite assessment: hazards, resources, working zone and documentation. Outcome 2 covers operation: raise, lower, slew, extend and retract, safe working load, inclination warnings and recovery, emergency controls, protective equipment, fault reports and shutdown for travel. Assessment of EWP skills in an electricity supply or horticulture environment falls under other standards setting bodies' unit standards.
New Zealand: unit 24561, quad bike with trailed equipment
The unit describes a quad bike as a vehicle with handlebars and thumb-operated throttle, four low-pressure tyres, an engine of at least 200cc, a gross weight under 1000kg and a fixed rear axle. For assessment, the candidate keeps control in five difficult situations, such as uphill, downhill, traversing a slope, wet or loose surfaces and rough terrain. Training and assessment on rolling terrain do not exceed a 20 degree slope. The candidate wears a helmet meeting NZS 8600:2002 or an approved motorcycle helmet.
Version 4 is dated July 30, 2026, and NZQA gives December 31, 2028 as the last date for assessment. The unit and units 24559 and 24563 were replaced by skill standard 41346.
Great Britain: NPORS cards and categories
NPORS says its training and testing follow published course objectives and learning outcomes derived from the National Occupational Standards. It runs 130+ courses grouped into eight categories: Lift Truck and Cranes, Access Equipment, Miscellaneous Equipment, Earthmoving Machinery, Street Works, Health and Safety, Transportation, and Small Equipment.
| Card | Who it is issued to | Validity |
|---|---|---|
| NPORS Traditional | Operators in sectors other than construction, with no CSCS logo on the card | 3 or 5 years, chosen by the end user |
| NPORS CSCS Trained Operator (red) | Construction operators who do not hold the required (S)NVQ | 2 years, during which the operator registers for and achieves the (S)NVQ |
| NPORS CSCS Competent Operator (blue) | Construction operators who hold the required (S)NVQ | 5 years, with a CPD record and operator logbook |
The CSCS routes follow requirements set by the Construction Leadership Council. They need a pass in the plant category training and testing with a registered NPORS instructor, plus an NPORS or CITB health, safety and environment touch screen test taken within two years before the application.
Sources
- New Zealand Qualifications Authority, Unit standard 23961 version 4, truck-mounted EWP, read October 15, 2026
- New Zealand Qualifications Authority, Unit standard 24561 version 4, quad bike with trailed equipment, read October 15, 2026
- NPORS, Card information, read October 15, 2026
- NPORS, Plant operator training standards and categories, read October 15, 2026