ArbNation Join free

Root protection formulas by standard: BS 5837, AS 4970 and council guides, as printed

BS 5837 and AS 4970 both set a protected radius of 12 times the trunk diameter. The British figure is capped at 707 square metres. The Australian radius runs from 2 to 15 metres in two council guides.

Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The formulas come from council guides that restate the standards, which are paid documents.

Formulas as printed

Protected area formulas by standard
StandardFormula as printedPrinted by
BS 5837:2012Root Protection Area (RPA) of a single stem tree: a circle with a radius of 12 times the stem diameter. Capped at 707 m2 in all casesBarrow Borough Council guidance, February 2020
AS 4970-2009Tree Protection Zone (TPZ) radius: DBH times 12, with DBH measured at 1.4 m above ground. Not less than 2 m and not more than 15 m from the trunkA Victorian shire council guide (MRSC)
AS 4970-2009, palms, cycads and tree fernsNo calculation. The TPZ is not less than 1 m outside the crownCity of Ryde, Tree Management Technical Manual
ANSI A300 Part 5No formula on the association's pageTree Care Industry Association

BS 5837

BSI lists BS 5837:2012, Trees in relation to design, demolition and construction. Recommendations, as published on April 30, 2012. Its status reads Current, Under Review, and it supersedes the 2005 edition. Barrow Borough Council describes the RPA as the minimum area in square metres left undisturbed around each retained tree to keep the tree viable. Its worked examples give a 75 cm stem a radius of 900 cm, a 125 cm stem a radius of 1500 cm and a 27 cm stem a radius of 324 cm. The guidance lists BS5837 under useful reading but does not say that its formula is taken from the standard.

For trees with more than one stem, Barrow gives two methods for a combined stem diameter: one for two to five stems and one for more than five. The council adds that the RPA starts as a circle centred on the base of the stem. A polygon of equal area replaces it where rooting has been lopsided because of past or existing site conditions.

AS 4970

Standards Australia published AS 4970-2009, Protection of trees on development sites, on August 26, 2009, and reissued it with Amendment No. 1 in March 2010. The shop.standards.ie catalogue marks it as superseded by AS 4970:2025 on May 29, 2025, and the guides below cite the 2009 edition. The free sample on a council site lists clause 3.2, Determining the TPZ, clause 3.3, Variations to the TPZ, and Appendix D, Encroachment into Tree Protection Zone.

The shire council guide says the TPZ takes in the structural root zone (SRZ). Its fencing rule for home projects that need no planning permit uses the same radius, 12 times the trunk diameter at 1.4 m, with the 2 m floor and 15 m ceiling. The City of Ryde manual calls the TPZ formula for multi-stem trees complex and points readers to a calculator on its own site. The manual was adopted on August 21, 2012, updated on August 10, 2016, and the file carries a draft mark on its later pages.

The Ryde manual also records a local reading of the standard. It treats an encroachment of less than 10 percent of the TPZ area as usually minor. Encroachment above 10 percent is usually major. For that, or for any encroachment into the SRZ, the manual says advice is sought from the project arborist, who decides whether the tree stays viable.

ANSI A300

The Tree Care Industry Association describes A300 Part 5 as the part that applies to management, and the writing of management plans, for trees during site planning, development and construction. Its listed topics include barriers, excavation and trenching, fill soil, utilities and pavement. The page prints no root protection formula.

Sources