Sight triangles and pruning at junctions: TxDOT, NJDOT and Manual for Streets figures
New Jersey's design manual lists overhanging branches to be removed up to 16 feet over the roadway. Britain's Manual for Streets uses a 2.4 m setback for junction visibility splays in built-up areas.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. No city highways code was opened for this page.
Texas: TxDOT Landscape and Aesthetics Design Manual, section 3.3
TxDOT's section on sight visibility triangles says the triangles should allow a full view of traffic for all turning movements at intersections, including driveways and median turns, and for merging movements at ramps. The exact dimensions depend on highway function and speed, and the section points to Roadway Design Manual Chapter 4, Section 4.11.4 for intersection sight distance. Materials used should maintain and enhance lines of sight through the intersection.
The figure captions say plants must not be placed where they may obstruct signage. Visibility within intersections is a primary goal, so plant material must be limited to low-growing varieties. Approach ramps require long, unobstructed sight lines.
The manual puts the primary cone of vision at 60 degrees for a stationary observer. For most drivers it estimates the cone at 30 degrees. Objects 20 feet from the pavement edge and 120 feet from the viewer fall within that 30 degree cone.
Section 3.3.1 lists the goals of roadside vegetation maintenance: sight distance, clear view of obstructions, erosion control and aesthetics.
New Jersey: NJDOT Roadway Design Manual
The NJDOT Roadway Design Manual attachment BDC17MR-05, from the guide rail chapter, covers trees near roads. Trees that cause sight distance problems are to be removed despite public criticism. Trees, shrubs and overhanging branches are to be removed where they block or obscure horizontal sight distance, whether they are behind guide rail or not. As a minimum, branches overhanging the roadway are removed up to a height of 16 feet.
The manual lists four places to check for vegetation interfering with sight distance.
- Along the inside of horizontal curves on the mainline, ramps and jughandles.
- At ramp and jughandle entrances and exits.
- Within the sight triangle at intersections.
- At sign obstructions.
Where clearing is needed within existing utility lines, the designer asks the utility company to do regular trimming at its own cost. Where poles are relocated, the utility or contractor is compensated for the work. Trees removed for safety, including for sight distance, are not counted in the No Net Loss Reforestation calculation. The manual notes that removal of trees and shrubs may be regulated under the Flood Hazard Area Control Act for riparian zones or the Freshwater Wetlands Protection Act.
Table 8-2 gives guidance for new plantings. It allows no plantings within the sight triangle on curves and ramps. On curves and ramps, shrubs and shade trees go at least 2 feet from the sight triangle. Evergreen trees go 10 feet away on Interstates and freeways, and 6 feet away on land service state highways.
Great Britain: Manual for Streets
The Department for Transport's Manual for Streets covers residential streets. It does not apply to the trunk road network. The visibility splay at a junction gives adequate inter-visibility between vehicles on the major and minor arms.
The X distance runs back along the minor arm from the give way line. An X distance of 2.4 m should normally be used in most built-up situations. A minimum of 2 m may be considered in some very lightly trafficked, slow-speed situations. The manual says an X distance above 2.4 m is not usually required in built-up areas. The Y distance, along the main arm, is based on stopping sight distance.
| Speed | Stopping sight distance | Adjusted for bonnet length |
|---|---|---|
| 20 mph (32 km/h) | 22 m | 25 m |
| 25 mph (40 km/h) | 31 m | 33 m |
| 30 mph (48 km/h) | 40 m | 43 m |
On trees, the manual says that in general, occasional obstacles to visibility that cannot fully obscure a whole vehicle or a pedestrian, including a child or wheelchair user, will not have a significant impact on road safety. Street trees and lighting columns are assessed for their impact on the envelope of visibility as a whole.
Section 11.3.4 says trees and shrubs should not obstruct pedestrian sightlines. Driver sightlines also need to be maintained in general, although vegetation can be used to limit excessive forward visibility and so traffic speeds. It suggests considering slow-growing species with narrow trunks and canopies above 2 m. Vegetation should not encroach onto carriageways or footways. The GOV.UK Manual for Streets publication page dates the manual to March 29, 2007.
Sources
- Texas Department of Transportation, Landscape and Aesthetics Design Manual, Chapter 3, Section 3 Sight Visibility Triangles, read October 19, 2026
- New Jersey Department of Transportation, Roadway Design Manual, Section 8, attachment BDC17MR-05, read October 19, 2026
- UK Department for Transport, Manual for Streets, 2007, PDF, read October 19, 2026
- UK Department for Transport, Manual for Streets, GOV.UK publication page, read October 19, 2026