ArbNation Join free

Soil drench, trunk injection, basal bark and foliar spray: how systemic insecticides move

Systemic insecticides for emerald ash borer reach the crown through the root zone, the lower trunk bark or holes drilled into sapwood. Extension bulletins describe how each route loads the tree and what each leaves in soil and water.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

Extension bulletins and one maker sheet describe how these insecticides are put into ash trees. It is not training and does not teach the work. Systemic products are labeled pesticides, and the bulletin used here says many products registered against emerald ash borer can be applied only by licensed applicators and that anyone applying a pesticide must follow the label.

Four routes into the tree

A 2011 bulletin by University of Minnesota, Ohio State and Michigan State entomologists names three active ingredients used on ash: imidacloprid, dinotefuran and emamectin benzoate. All three are carried in the vascular system from roots and trunk to branches and leaves. The bulletin ties that movement to fewer hazards than spraying trees with broad-spectrum insecticides: less drift to non-target sites, less applicator exposure and less impact on beneficial insects.

Routes for systemic insecticides in ash, as the bulletin records them
RouteWhat the bulletin records
Soil drench or soil injectionImidacloprid or dinotefuran poured on the soil surface or injected a few inches below it
Basal bark sprayDinotefuran sprayed on the bark of the lower five feet of the trunk
Trunk injectionEmamectin benzoate and certain imidacloprid formulations injected into the base of the trunk
Foliar sprayThe broad-spectrum comparison; emamectin benzoate is registered as a foliar spray for vegetable and cotton crops

Soil routes

For soil applications, the bulletin puts the product immediately beside the trunk. It says this increases uptake, because the high density of absorptive roots there filters the chemical from the soil. These insecticides bind to organic matter, silt and clay, which limits their movement. The authors say they should not go on porous sandy soils lacking organic matter, especially where the water table is shallow or heavy rain is forecast within 24 hours. They also name soil near ponds, lakes or streams, and sloped surfaces where runoff can occur.

Imidacloprid was rarely detected in surface water in United States and Canadian surveys. In groundwater it was usually not detected, and when found it was mostly under 1 part per billion, with a maximum of 7 ppb. Dinotefuran is more soluble in water, and the bulletin says it has not been monitored the same way. Trunk-injected products pose little risk to ground and surface water when used as directed, because the material is placed inside the tree.

Trunk injection

A University of Illinois note on microinjection, dated April 11, 2001, describes holes drilled or bark punctured about 4 to 6 inches apart near the base or root flare, with material injected into the sapwood at low pressure. It explains uptake: pressure in the xylem is lower than the air outside because of water loss from the leaves, so injected liquid is drawn into the sap stream. The note puts uptake at about 2 to 4 hours, depending on weather, tree age, tree health and soil temperature, and says movement is highest in fall or spring. Uptake is best above a soil temperature of 45 F. American elms, which lack a porous xylem, cannot take large volumes this way.

A maker's fact sheet for one injection system states that injections go into the bottom 18 inches of the trunk about 6 inches apart, 5/8 to 1 5/8 inches deep. It adds that formulations can take hours to weeks to move through a tree and most often protect it within a few days. These are the maker's own figures.

The Illinois note lists concerns: wounds that are not small and shallow, the wrong number or depth of capsules, holes lined up vertically, tree health compromised by wounding, and uneven distribution in the crown. A 2011 paper in Arboriculture and Urban Forestry sectioned injected green ash trunks. All healthy trees closed the injection wounds with no sign of infection, decay or structural damage over two years. Wound closure rose with tree health, measured by annual radial growth.

Other effects the bulletin records

Ash is wind-pollinated and not a nectar source, so the authors call bee exposure highly unlikely. They add that flowering plants should not be planted next to ash treated through the soil, since those plants can take up the insecticide. Imidacloprid is fatal to honey bees when it reaches high enough concentrations. All of these ash products also affect other insects feeding on treated trees. Resistance in emerald ash borer is described as highly unlikely, because most of the beetle population never meets the insecticide.

More on injection methods is in the trunk injection methods guide, and label wording is in the pesticide label guide.

Sources