ArbNation Join free

State DOT roadside tree management policies

Washington sets replacement ratios by trunk size, Louisiana defines a significant tree at 18 inches and Caltrans fixes 17 feet of clearance over the road. Each state transportation department publishes its own tree removal and replacement policy.

Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. Three state transportation departments publish policy on trees in highway right-of-way. Washington State DOT (WSDOT) has its Roadside Policy Manual M 3110.04 of February 2022. Louisiana DOTD has its Policy for Roadside Vegetation Management. Caltrans has Chapter C2 of its Maintenance Manual, dated July 2014.

At a glance

Tree definitions and replacement terms in the three policies
DepartmentWhat counts as a treeReplacement term
WSDOTCategories by trunk diameter: under 4 inches, 4 to 30 inches, over 30 inchesOne 1-gallon tree per inch of trunk diameter for the middle category; 1:1 at 2.5-inch caliper for street and boulevard trees
Louisiana DOTDSignificant tree: 18 inches or more in diameter, or judged viable and aesthetically important, or significant to the local communityTwo replacement trees for each tree of 10 inches or more cut on public land, under R.S. 3:4271, where space allows
CaltransWoody perennial 4 inches or more across at 4 feet and over 20 feet tallLive tree removal needs approval; the chapter has no replacement ratio

Washington State DOT

The manual states that WSDOT preserves mature roadside vegetation and soils to the greatest extent feasible. WSDOT and Federal Highway Administration policy is to remove vegetation only for highway purposes, and WSDOT does not remove vegetation simply to enhance views to or from its highways. A Roadside Vegetation Permit process exists where the department benefits.

The manual divides the roadside into three zones.

  • Zone 1 is the vegetation-free or routinely mowed strip next to the pavement.
  • Zone 2 is the clear zone or recovery area for errant vehicles, and it includes Zone 1.
  • Zone 3 runs from the clear zone to the right-of-way line and holds native or naturally occurring vegetation.

Replacement ratios apply to projects that remove trees. Impacted trees are identified on a plan sheet by species and diameter, and the manual sets these terms:

  • Street or boulevard trees: replace 1:1, at 2.5-inch caliper balled and burlapped.
  • Category 3, small conifers and other late successional trees under 4 inches in diameter, and all shrubs: replace the disturbed functions.
  • Category 2, moderate-size trees from 4 to 30 inches in diameter at 4.5 feet: one 1-gallon replacement tree for each inch of trunk diameter, or the equivalent from the Tree Replacement Calculator Tool in the manual's Appendix D.
  • Category 1, mature, old-growth, large specimen, historical or heritage trees over 30 inches: project-specific restoration set after consulting the regional or headquarters landscape architect.

The manual treats department maintenance removals separately. In Zones 1 and 2, where a tree must come out of the clear zone during ongoing maintenance, no replacement is required. In Zone 3, removing a single tree that presents a current danger to public safety needs no replacement. A single weak-wooded tree in a location of increasing risk is removed as maintenance work allows. A stand of undesirable species such as cottonwood or alder may be swapped for more stable species through the area integrated roadside vegetation management plan. In sensitive areas such as stream or wetland buffers, the Region Maintenance Environmental Coordinator evaluates regulatory impacts and mitigation, and the landscape architect sets the planting number.

Louisiana DOTD

The policy cites Act No. 682 of the 1989 Regular Session, and the rule took effect on August 20, 2000. The general conditions call for trimming or removing trees that interfere with sight distance or with side and overhead clearance. All dead trees, and leaning trees with weakened root systems, that may fall across the highway are to be removed and disposed of in a timely manner. Stumps in a mowable area go to ground level, and stumps in areas that are not mowed may stay if cut within 5 inches of the ground.

Engineering directive EDSM I.1.1.21, effective October 18, 1999, covers significant trees in the right-of-way. It defines a significant tree as one 18 inches or more in diameter, or judged viable and aesthetically important by the department's landscape architect, or considered significant by one or more members of the local community. Its design principles run in order: avoid conflicts with trees of local value, limit the disturbance where avoidance fails, and mitigate unavoidable impacts through compensation to the landowner, replacement or enhancement elsewhere. At the minimum, mitigation meets R.S. 3:4271, which requires two replacement trees for each tree of ten inches diameter or more removed from public land or rights-of-way, provided space is available.

Removing a significant tree is to follow only after reasonable efforts to preserve it are exhausted, and it needs the Chief Engineer's concurrence. The directive adds that no removal goes ahead without notifying the affected community of the department's intentions and reasons. For maintenance, the clear zone used in design is kept free of new growth, and the landscape architect is consulted before significant trees are cut or pruned.

The policy also holds guidelines for vegetation visibility permits for advertising displays. Visibility work is not undertaken where the display has been in place under five calendar years or where the vegetation lies more than 500 feet along the highway from the display, and stumps are cut or ground flush and treated.

Caltrans

Chapter C2 of the Caltrans Maintenance Manual lists California laws on highway vegetation. Penal Code section 384(a) bars negligence including cutting and removing plants growing on state or county highway rights-of-way, public land and land not owned by the person doing so, without written permission from the owners. Streets and Highways Code section 730.5 lets the state recover US$10,000 for each tree damaged and US$1,000 for each shrub. Sections 1495 and 670 cover injury to trees on highways and the removal or planting of trees and shrubs on state highways.

The chapter sets 17 feet of clearance over the traveled way and shoulder for trimming. The chapter says district policy sets the approvals for removing a plant or tree, and signatures from the Landscape Specialist and above may be required before a live tree comes out. In the topping section, live tree removal must be approved by the District Director. Dead plants or trees in the right-of-way are removed promptly when safety or adjacent property requires it. Highway trees may be topped only if extreme height has made them a hazard to traffic or property.

Annual Tree Inspections are carried out by Tree Risk Assessment Qualified personnel along all district, county and route sections every fiscal year, a programme begun in 2010. The inspections cover roadside and landscape areas, rest areas, vista points and park and ride lots. They look for decay, leaners, codominant stems, hangers, cracks, splits and dead branches, and for encroachment and sight distance problems. The chapter also states that only qualified personnel are authorized to fell trees.

Sources