Static and dynamic cabling compared: what conference research and makers publish
Arborists, a 2013 sway study on cabled oaks and a cable maker describe steel static cables and rope-type dynamic cables differently. The maker's brochure calls dynamic cabling the best answer, while the conference slides present cabling as one of many options.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
This page draws on conference slides and a maker brochure. It is not training and does not teach the work. The standards the sources cite are covered in the guide to cabling and bracing trees.
A 2025 conference talk on static and dynamic cables
Allen Taylor of Conservation Tree Care and Connor McDermott-Grossman of Tree Solutions Inc. presented "Dynamic Cables: Are they the Best Option?" at the 2025 Futures in Applied Arboriculture meeting. The University of Washington Botanic Gardens posts the slides. The slides ask why dynamic cables are so prevalent. Their answer lists easy upselling, ready availability, fairly easy installation, affordable upfront cost and varied uses.
For static steel cabling the slides list these benefits: long lifespan, rare adjustment (although inspection is required), active support and no animal damage. The drawbacks listed are possible shock loading in some situations, some damage to the tree during installation, and harder installation than dynamic cables. Pruning, bracing, target management and improving tree vigour appear on the same slides as other ways to mitigate risk.
The slides give these use cases for dynamic cables: no appropriate installation point for a static system because of trunk decay, maximum maintenance of natural movement, use as part of a catch system, and use together with other supports. They add that the client's ability to perform the required maintenance is critical.
On standards, the slides say ANSI A300 Part 3 is largely focused on static cabling and gives limited guidance on inspection and maintenance. They say most dynamic installation and maintenance guidelines come from manufacturers. They also say the European cabling and bracing standard puts steel cables in the static zone, the lower half of the crown, and dynamic cables in the dynamic zone.
A 2013 study of cabled red oaks
Mark Reiland, an ISA certified arborist, presented a study to the 2013 ISA conference on how steel support cables and leaves change the sway of large trees with codominant trunks. He tested 10 northern red oaks of similar size, 5 cabled and 5 not. Free vibration tests ran in winter 2012 with the trees bare and in summer 2012 in leaf.
Both cabling and leaf condition had a significant effect on natural sway frequency. Cabled trees had higher frequencies than uncabled trees, and trees in leaf had lower frequencies than bare ones. Only leaf condition had a significant effect on the damping ratio, and trees in leaf had larger ratios.
Reiland concludes that trees are underdamped structures and that the maximum damping should be preserved in all arboricultural operations. His slides record that pruning treatments were not part of the study and that more research is needed on pruning together with cable installation.
Maker literature
SherrillTree's undated cable brochure says steel wire was first used as tree cabling in the early 1900s. Steel has virtually no capacity to absorb shock loading, and installers pull it taut to limit fatigue. Rope-type dynamic cable absorbs shock and is installed relatively loose. A warning in the brochure adds that supports are not made to hold dying trees together.
Its comparison table gives the figures the maker declares for these systems.
| System | Tensile strength | Useful life expectancy | Shock absorbing |
|---|---|---|---|
| Cobra Mini, rope-type | 1 ton | 10 years | Yes |
| Cobra Plus, rope-type | 4 tons | 10 years | Yes |
| TreeSave 10/5, polyester | 2.5 tons | 15 years | Yes |
| TreeSave 10/20, polyester | 10 tons | 15 years | Yes |
| 1/4 inch extra-high-strength steel | 3.5 tons | 25 years | No |
| 3/8 inch extra-high-strength steel | 7.5 tons | 25 years | No |
The brochure prints a different figure for the smallest rope-type system in another place: it lists Cobra Mini at 1.5 ton in its size guide. A note under the table says most cable systems need repositioning or replacement within 10 to 15 years because of tree height and diameter growth. In the text the maker puts usefulness of any cable at around 10 years, though cables can physically last up to 50.
Where the sources disagree or stop
The conference talk weighs static and dynamic cables against other ways to mitigate risk. The brochure comes from a cable maker and calls dynamic cabling materials like its own the best answer to a more natural supplemental support system. Reiland tested only steel cables on one species. None of the three sources is a peer-reviewed journal article.
Sources
- Taylor and McDermott-Grossman, Dynamic Cables: Are they the Best Option?, Futures in Applied Arboriculture 2025, University of Washington Botanic Gardens, read October 19, 2026
- Reiland, The effects of leaves and steel support cables on northern red oak with co-dominant trunks, ISA conference proceedings 2013, read October 19, 2026
- SherrillTree, Dynamic Cabling System brochure (undated), read October 19, 2026