ArbNation Join free

Stump killers: what herbicide labels and extension say

Penn State Extension and the University of Arizona describe cut stump herbicide treatment with glyphosate and triclopyr. A triclopyr 8.8% label that EPA stamped 'Notification' gives its own stump directions.

This page is for tree owners. It reports what the named sources say and is not advice about your tree: for that, ask a qualified arborist or one of the offices under Who to call.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

The extension pages and the EPA-accepted label are described as published. It is not training and does not teach the work.

What a cut stump treatment is

Penn State Extension describes a cut stump herbicide treatment as a method to control woody plants. A systemic herbicide goes straight onto the cut stump to stop resprouting from the plant tissue that remains. Glyphosate and triclopyr are the two common active ingredients. Glyphosate is water soluble. Triclopyr comes in water-soluble and oil-soluble formulations.

The University of Arizona Cooperative Extension bulletin by Jeff Schalau, a Yavapai County agent, explains why the treatment exists. Many trees and shrubs send up new shoots from buds at or below ground level when the top comes off. Those stump sprouts regrow vigorously on energy stored in the roots. Where hand removal or machine removal is not practical, the bulletin says herbicide on a freshly cut stump can kill the plant and prevent regrowth.

Stump directions on a triclopyr label

An EPA notification letter dated October 21, 2019 covers the residential label for Triclopyr 8.8% Herbicide (EPA registration number 53883-216). The letter says the submitted label was stamped "Notification" and placed in EPA's records. The product is labelled for woody plants, vines and broadleaf weeds around homes, cabins, fences and walkways, for outdoor residential use only.

Its stump directions are short: "Apply this product undiluted to kill stumps and prevent sprouting." The label names a paint brush, a backpack sprayer or the applicator top to cover the freshly cut surface completely. Its foliar directions are separate and use a diluted mix. The label's woody plant list includes ash, elm, maples, oaks, pine and willow.

The label prints a federal-law line: "It is a violation of Federal law to use this product in a manner inconsistent with its labeling." Its environmental section keeps the product out of storm drains, ditches, gutters and surface waters. The chemical has properties associated with groundwater detections, so permeable soil over a shallow water table may bring contamination.

Timing and stump size

Penn State's video separates stumps by diameter. On stumps four inches or larger, it describes a water-soluble herbicide going on the living sapwood right after cutting. Sapwood is the lighter wood next to the bark that carries water and minerals. An oil-soluble herbicide mixed with basal oil can go on at any time after cutting and before resprouting, on the sapwood and the sides of the stump down to the root collar. On stems under four inches, every exposed face is treated.

Penn State prefers late summer and fall, when woody plants move carbohydrate reserves underground and carry the herbicide down with them. It says spring treatment is ineffective because of upward sap flow. Arizona agrees that in general fall applications are most effective, and notes that most labels recommend application within five minutes after cutting.

Where the two extension pages differ

Treatment points as each extension publication prints them
PointPenn State ExtensionUniversity of Arizona Cooperative Extension
Timing after the cutImmediately for water-soluble products on stumps four inches or larger. Any time before resprouting for oil-soluble products.The sooner the herbicide is applied, the more effective. Most labels recommend application within five minutes.
Best seasonLate summer and fall. Not spring.Fall.
Small stemsCut close to the soil line and treat every exposed face.Fraying the bark of small or previously cut stems exposes more phloem and may increase uptake. The frayed area is treated with the cut surface.
Follow-upWatch for resprouts and retreat as needed. Initial treatment may reduce root systems a lot but not entirely.Mulches are usually ineffective at controlling woody plant sprouts.

Products and species

Arizona lists common stump-killing active ingredients as 2,4-D, dicamba, glyphosate, imazapyr, picloram and triclopyr. The 2,4-D, dicamba and picloram products may be subject to flashback, the passive loss of herbicide from treated roots that can injure nearby plants. Glyphosate and triclopyr are not.

The bulletin gives these control ratings:

  • Glyphosate: good cut stump control of alder, ash, cottonwood, elm and Russian olive. Fair control of locust, oak, maple and willow.
  • Triclopyr: good control of alder, ash, cottonwood, elm, locust, oak, maple and willow. Fair control of Russian olive.

Penn State names tree of heaven as a tree where cut stump treatment is a poor method. Little herbicide reaches the roots, so the stump is controlled but the tree resprouts prolifically. It names basal bark or hack-and-squirt applications as better suited. Cut stump treatment works on beech, honeysuckle, autumn olive and Oriental bittersweet.

Shared roots and neighbouring trees

Arizona warns that many woody plants are connected underground to others of the same species. Suckers from an adjacent tree are one example, and root grafting is another. Herbicide on such sprouts can travel to the common root system and may kill trees that were not the target. It names tree of heaven, honey locust, black locust, hackberry, western soapberry, cottonwood, aspen, poplar, willow and box elder among the sucker producers. Its text says never to use herbicide on sprouts from the root system of a tree that is wanted.

Forest Service records on 24 species are in the stump sprouting by species guide. Grinding and digging are in three extension descriptions of stump removal. Label and worker rules are in pesticide and herbicide handlers.

Who to call

Sources