Trailer lights, reflectors, safety chains and plates: US and UK rules
49 CFR 393.11 splits trailers at 2,032 mm (80 inches) wide for clearance and identification lamps, and 393.71 asks for at least two safety chains in tow-bar operations. The UK Road Vehicles Lighting Regulations 1989 list trailer lamps in Schedule 1, Table VI.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. The US texts are 49 CFR 393.11 on lamps and reflective devices and 49 CFR 393.71 on coupling devices and towing methods. The UK text is the Road Vehicles Lighting Regulations 1989, SI 1989/1796, in the version as made.
US: lamps and reflectors under 49 CFR 393.11
Section 393.11 requires commercial motor vehicles made on or after December 25, 1968 to meet 49 CFR 571.108, known as FMVSS No. 108, as in effect at manufacture. Its Table 1 lists the lamps and reflective devices by type of vehicle. For trailers the table uses two types: D for semitrailers and full trailers 2,032 mm (80 inches) or more in width, and F for those narrower.
| Device | Type D, 80 inches or wider | Type F, narrower |
|---|---|---|
| Tail lamps, 2 red, 381 mm to 1,829 mm high | Listed | Listed |
| Stop lamps, 2 red | Listed | Listed |
| Rear turn signals, 2 amber or red | Listed | Listed |
| Rear reflex reflectors, 2 red, 381 mm to 1,524 mm high | Listed | Listed |
| Side marker lamps (2 amber front, 2 red rear) and side reflex reflectors | Listed | Listed |
| Rear license plate lamp, 1 white | Listed | Listed |
| Clearance lamps and 3 rear identification lamps | Listed | Not listed |
Footnote 11 says the plate lamp is illuminated when the headlamps are. No rear plate lamp is required on a vehicle that displays no rear plate. Footnote 16 exempts a trailer under 1829 mm (6 feet) long, tongue included, from front side marker lamps and front side reflectors. Pole trailers and converter dollies follow the Part 393 rules in effect at manufacture.
Paragraph (b) adds a conspicuity system on each trailer 2,032 mm or more wide with a GVWR over 4,536 kg (10,000 pounds), made on or after December 1, 1993. Pole trailers and living or office trailers are excepted. The system is retroreflective sheeting, reflex reflectors or a combination that meets FMVSS 108. Trailers with conspicuity material at the Table 1 reflector locations do not need the reflex reflectors, if the material meets the visibility requirements for them. Paragraph (c) bars amber stop lamps and tail lamps on commercial motor vehicles.
US: safety chains under 49 CFR 393.71
Section 393.71 covers coupling devices and towing methods in driveaway-towaway operations. Paragraph (h)(10) deals with tow-bars. The towed vehicle is connected to the towing vehicle by a safety device that stops it breaking loose if the tow-bar fails or becomes disconnected.
- Where chains or cables are the safety device, at least two are used.
- Their tensile strength, and the way they attach, is at least equal to the tow-bar longitudinal strength in the paragraph (h)(1) table. For chains or cables, the required strength is the combined strength.
- They are crossed and attached near the bumper attachment points. Chain length is no more than needed for free turning, and the chains attach to the tow-bar at the crossing point or as close as practicable.
- A device other than chains or cables must match their strength, security of attachment and directional stability, and must keep the tow-bar from dropping to the ground.
Paragraph (d) bars a tow-bar that depends on the bumpers from towing a motor vehicle weighing more than 5,000 pounds.
UK: Road Vehicles Lighting Regulations 1989
The Regulations were made on 28 September 1989 and came into force on 1 November 1989. Regulation 18 requires each vehicle of a class in a Schedule 1 table to be fitted with the lamps, reflectors and rear markings of the types listed there, meeting the installation and performance requirements in the later Schedules. Regulation 23 bars use on a road unless the lamps, reflectors and markings it names are in good working order, and the lamps clean.
The definitions treat an agricultural vehicle as one built or adapted for agriculture, grass cutting, forestry, land levelling, dredging or similar operations, and primarily used for them. Any trailer drawn by an agricultural vehicle is included.
Schedule 1, Table VI covers a trailer drawn by a motor vehicle.
| Item | Exceptions listed in the table |
|---|---|
| Rear position lamp | None |
| Rear retro reflector | None |
| Front position lamp | Width not over 1600 mm; some small trailers made before 1 October 1985; boat launching trailers |
| Direction indicator | Trailers made before 1 September 1965; agricultural vehicles or works trailers made before 1 October 1990 |
| Stop lamp | Agricultural vehicle or works trailer |
| Rear registration plate lamp | A trailer not required to be fitted with a rear registration plate |
| Side marker lamp | Trailers up to 6 m long, or 9.15 m if made before 1 October 1990, plus several other classes |
| Rear fog lamp | Trailers made before 1 April 1980; width not over 1300 mm; agricultural vehicle or works trailer |
| Rear marking | Trailers with a maximum gross weight not over 3500 kg, plus several other classes |
Schedule 15 sets the rear registration plate lamp: it adequately illuminates the plate, and its colour is white. A trailer made on or after 1 October 1985 carries an approval mark on it. Schedule 18 calls for two rear retro reflectors in the usual case, at most 400 mm from the side of the vehicle, or 765 mm on a vehicle built for round timber.