ArbNation Join free

Two points of attachment: where each code asks for a second attachment and when

Four official texts ask for a second attachment in a tree. SafeWork NSW and WorkSafe New Zealand tie it to cutting, HSE to a backup for work positioning where reasonably practicable, and the ICoP to a backup for the primary system.

Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. It is not training and does not teach the work.

The triggers, source by source

SourceWhen a second attachment is asked for
HSE, Tree climbing, United KingdomIn the tree, where possible, the system should be securely attached to 2 anchor points, each strong enough for the climber, the work equipment and any foreseeable loading. Work positioning should be used only with a suitable backup for preventing or arresting a fall, and if the backup includes a second line, the user must be connected to it. Where a backup is not reasonably practicable, the system is kept from failing by training, properly chosen equipment, reliable anchor points, following industry and HSE guidance, and the correct use of tools.
ICoP, United Kingdom, 3.8.6It is expected that a proficient operator on a personal fall protection system has a backup that prevents a fall likely to cause injury if the primary system fails, including main line, components or anchor. The backup should use an anchor independent of the primary one where possible, or else be installed over a shared anchor. It may be left out only where it is not practical to keep it for specific, short-duration tasks, with all measures taken so the primary anchor and system cannot fail.
SafeWork NSW, section 4, New South WalesA second attachment point, meaning a climbing lanyard or a second rope system, is a listed control in four cases. They are cutting work in a tree, a risk of an uncontrolled swing, a risk that the main climbing line or primary anchor point fails, and an anchor point that is not above the work area. Section 4.9 says climbers carry at least two methods of attachment, and use two points of attachment when operating cutting equipment or where extra stability is needed, preferably from independent anchor points.
WorkSafe NZ code, 3.1.6 and 3.2.2, New ZealandThe climber is attached by two anchor points when making cuts aloft. Section 3.2.2 repeats that a second anchor point is needed when cutting, and adds that supplementary anchor points shall be used where a fall or swing that may cause injury is possible.
SafeWork NSW, crane access method, New South WalesWhen a crane helps a worker into a tree, the worker moves across using two independent attachment points. Trimming or cutting starts only when the worker is secured by two attachment points, one of which should be able to serve as an alternative means of descent. Two points are kept when using cutting equipment, repositioning or moving past junctions, and the next system is checked and preloaded before the existing one is released.

Where the sources differ

Cutting is the one trigger the NZ code and the NSW code share. Both name it directly, while HSE and the ICoP frame the second attachment as a backup to the primary system, not as a cutting rule. The NSW list adds uncontrolled swing and an anchor that is not above the work. HSE leaves room for no backup where it is not reasonably practicable, and the ICoP leaves room for short, specific tasks.

The HSE page also covers rope access and positioning, where it names at least two separately anchored lines: a working line and a safety line, with the user connected to both. That classification is set out in the guide to rope access versus work positioning in tree work. HSE's aerial work page adds that at least 2 people must be present during all aerial work. Other attachment rules are collected in the guide to tie-in and second attachment rules.

Sources without a matching rule

OSHA's June 24, 2021 enforcement memo carries no wording on a second attachment, so the United States has no row.

Credits: HSE wording is adapted from pages licensed under the Open Government Licence v3.0. SafeWork NSW text is adapted from the Tree works code of practice (March 2026), copyright State of New South Wales (SafeWork NSW), licensed under Creative Commons Attribution 4.0; changes were made, because the text is summarised and reworded. WorkSafe New Zealand material is summarised from its Approved Code of Practice for Safety and Health in Arboriculture, with the source acknowledged.

Sources