Underground guying, tree anchors and root-ball anchoring: types and what specs require
Guys pull a trunk to ground anchors: stakes, augers, a deadman buried 2 to 3 feet down, or a buried frame over the root ball. Purdue, the University of Hawaii and Oregon DOT print the sizes and limits.
Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.
Guys, anchors and buried root-ball systems for larger trees are described here from two extension services and a state transport agency. It is not training and does not teach the work.
Two ways to hold a tree
Purdue Extension (FNR-547-W, July 2017) separates staking from guying. Staking ties a trunk to a nearby steel or wooden post and is the common approach on smaller trees and container stock. Guying is temporary and usually used on larger balled-and-burlapped trees. Purdue calls three points of attachment the best support for these large installations. The University of Hawaii CTAHR leaflet L-7 (June 1998) puts guying on trunks greater than 4 inches in diameter, with three or four wires attached to the tree and anchored in the ground.
Hawaii also describes anchor staking, which holds the root ball in place until new roots grow into the surrounding soil. It names trees on uncompacted, loose fill, trees with large unthinned canopies, and trees with only a small part of the root system attached, such as large field-harvested stock.
Anchor types by where they sit
| Type | What it is | Source and figures |
|---|---|---|
| Stake | A wooden or metal stake driven in beside the tree, with a guy wire to the trunk | Hawaii calls stakes the most common and least expensive anchor, which can loosen or pull out. Purdue gives a 45-degree angle for the guy between the anchor point and the attachment point on the trunk |
| Small auger anchor | A small metal auger that takes the guy wire | Purdue: reusable and easily adjusted for depth |
| Land anchor | An anchor set in the ground | Named by Hawaii alongside stakes and the deadman, with no description or dimensions given |
| Deadman | A wooden beam or concrete block buried below the surface | Hawaii: placed 2 to 3 ft below the soil surface |
| Buried root-ball system | A concealed anchor over the ball, covered by mulch or soil | Purdue: underground stabilizing systems are effective and economical on larger balled-and-burlapped trees. Several commercial systems exist, and a plain untreated wood frame held by wooden stakes is described as an option that degrades over time |
Purdue describes the wood frame in detail. Vertical stakes attach to the ends of horizontal boards laid over the ball. The stakes are driven up to 4 feet deep, or as deep as possible in the existing soil, so they do not loosen or pull out. Mulch can cover the whole system.
Attachment, tension and protection
Purdue gives the guy attachment as the lower half of the trunk, always less than 2/3 of the tree's height, to reduce the chance of the tree breaking at that point. Some movement is allowed, since it stimulates trunk taper and root anchorage. Excessive tension can break the trunk where it attaches, and a guy that is too loose provides no support. Purdue names wide, smooth, flexible material such as soft webbing as the better choice over wire in hose, because wire and hose can abrade the cambial tissue under the bark.
Hawaii describes a different attachment: guy wires pass through a section of hose or other protective material and then around the tree at crotches. Some professionals fit a turnbuckle for adjustment or springs for flexing. Hawaii warns that guy wires tied tightly girdle the trunk, and adds that streamers mark the wires to warn people. In turf, it shows guy wires attached to removable pins set in galvanized pipe flush with the soil.
Purdue places all support equipment inside the mulch ring where possible, which prevents damage from lawn equipment and helps eliminate trip hazards.
What a transport agency specifies
The Oregon Department of Transportation tree staking detail (DET6100, dated August 31, 2012) is a drawing with notes for tree planting beside roads. It specifies stakes rather than buried anchors. The stakes are Douglas fir or pine, 1-1/2 by 1-1/2 inches. A tree 36 inches or shorter gets one stake of about 6 feet, and a taller tree gets two stakes of about 8 feet.
The notes have stakes driven vertically at least 12 inches into undisturbed soil, not through the root ball. Ties are either a plastic chain type about 1 inch wide, or a rigid guy system with galvanized wire about 1/8 inch thick, 24 inches long, in a plastic sleeve where it circles the tree. The drawing notes tension guying to allow 4 inches of sway in any direction, and removal of the stake after one year. The agency also states that the selection and use of the detail is the sole responsibility of the user and that it should not be used without consulting a registered professional engineer.
How long the support stays
Purdue says staking trees too high, too tightly and for too long are the most common causes of tree damage. It puts removal at usually no later than one growing season or one year. A tree guyed too long is girdled at the attachment point, Purdue states, and trees held still for longer usually grow taller but thinner, with a smaller root system. Hawaii says never more than one year, and that planting contracts include removal of staking and guys. Oregon DOT's note says one year too.
Sources
- Purdue Extension, FNR-547-W Tree Support Systems, July 2017, read October 21, 2026
- University of Hawaii CTAHR Cooperative Extension Service, L-7 Staking and Guying Newly Planted Trees, June 1998, read October 21, 2026
- Oregon Department of Transportation, Technical Services Details, DET6100 Tree Planting and Staking Details, August 31, 2012, read October 21, 2026