Why a saw cuts crooked or pulls to one side: the causes makers list
Two saw makers trace a crooked cut to the chain, not the engine. Dull or uneven teeth come first, then incorrect filing angles and a worn or bent guide bar.
Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.
This page draws on troubleshooting articles from two saw makers. It is not training and does not teach the work. Each cause below is one a maker prints, and the remedies named are the makers' own.
Causes in the first maker's article
One saw maker's UK support article, dated 14 April 2026, calls a saw that pulls to one side common and usually caused by chain or guide bar problems rather than a major fault. It sorts the causes into three groups.
| Cause | Detail printed | Remedy printed |
|---|---|---|
| Dull or damaged chain | The most common reason. Uneven or blunt cutting teeth cause imbalance, and the chain cuts more on one side | Sharpening evenly, and replacing a chain that is damaged or heavily worn |
| Incorrect chain sharpening | Teeth on one side can be sharper than the other. Incorrect filing angles can affect cutting direction | Using the correct file size and sharpening both sides evenly |
| Wrong or damaged guide bar | The bar must be straight and true. Uneven wear on the rails, or a damaged or bent bar, misaligns the chain and forces the saw sideways | Inspecting the bar for wear or damage, and replacing it if necessary |
The article explains the mechanism in one line: a saw cuts straight when both sides of the chain remove wood evenly, and if one side cuts more aggressively the saw pulls that way.
A second maker's wording
A second maker's US sharpening guide lists a saw that pulls in one direction, with the cut becoming crooked, among the signs of a dull chain. It points to a dull chain, or to unevenly long teeth on one side. The second maker's Australian page lists the same sign as number four of five and calls it particularly indicative of blunt or unevenly long teeth on one side. The US guide's sharpening steps bring every tooth to the same length as the master tooth.
The US guide adds that cutters grow shorter with each sharpening, so the depth gauge setting needs a check afterward, and that a depth gauge set too low raises kickback. The second maker's UK blog notes that if only the cutting teeth are filed and the depth gauge is not lowered with them, the chain takes less wood out each time.
Checks and replacement points
The first maker's article prints a short list of what to look at before each job: chain sharpness, with clean teeth and uniform filing, and bar condition, meaning no bends, a clean groove and straight edges. The list continues with chain tension, neither too loose nor too tight, and lubrication, with the chain and bar oiler working. It names three triggers for replacing parts: the chain cannot be sharpened evenly, the guide bar shows visible wear or damage, or the problem continues after maintenance.
The first maker's article closes with its prevention list: sharpening the chain regularly, using the correct filing tools and angles, maintaining chain tension and inspecting the bar for wear.
Related guides
Signs of a dull chain are tabled in the guide to reading a dull or damaged chain. The guide to chain cutter types and sequences covers the chain designs themselves.
Sources
- Husqvarna UK, Why does a chainsaw pull to one side when cutting: Causes and fixes, article dated 14 April 2026, read October 16, 2026
- STIHL USA, How to Sharpen a Chainsaw, read October 16, 2026
- STIHL Australia, How to Sharpen a Chainsaw: Step-by-Step Guide, read October 16, 2026
- STIHL GB blog, How To Sharpen Your Chainsaw Chain, read October 16, 2026