Wood heater types in EPA rules: stoves, inserts, fireplaces, furnaces, hydronic heaters
EPA writes two rules for residential wood heating. Subpart AAA defines stoves, inserts and fireplaces. Subpart QQQQ defines hydronic heaters and forced-air furnaces and sets each class's emission limits and start dates.
Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. EPA splits new residential wood heating into two groups in 40 CFR Part 60. Subpart AAA covers heaters that warm the room they stand in. Subpart QQQQ covers central heaters, which send heat to other rooms through ducts or pipes.
The split between the two subparts
Subpart AAA, section 60.530, applies to the wood heaters it defines when they are manufactured or sold on or after May 15, 2015. It also applies to older stoves with an EPA certificate issued before that date. Subpart QQQQ, section 60.5472, applies to a residential hydronic heater, forced-air furnace or other central heater manufactured on or after May 15, 2015.
Each subpart excludes the other's appliances. Section 60.530 leaves out hydronic heaters and forced-air furnaces covered by QQQQ, residential masonry heaters, and appliances that are not residential heating devices, such as manufactured or site-built masonry fireplaces. Section 60.5472 leaves out heaters covered by AAA and residential masonry heaters.
Definitions in subpart AAA
Section 60.531 defines a wood heater as an enclosed, wood-burning appliance capable of and intended for residential space heating, or for space heating plus domestic water heating. Wood heaters may or may not have air ducts that send some heat to other areas.
| Class | EPA definition, restated |
|---|---|
| Free-standing wood heater | A wood heater installed on legs, on a pedestal or suspended from the ceiling. These are usually safety listed under UL-1482, UL-737 or ULC-S627. |
| Fireplace insert wood heater | A wood heater intended for a masonry fireplace cavity or another enclosure. These are usually listed under UL-1482, UL-737 or ULC-S628. |
| Built-in wood heater | A wood heater intended to be recessed into the wall. |
| Adjustable burn rate wood heater | A wood heater with a damper or other mechanism that lets the operator vary burn rate. The definition does not separate free-standing, built-in or insert models. |
| Single burn rate wood heater | A wood heater without a burn control device. Stack dampers and combustion air slides or gates count as burn control devices. |
| Pellet stove | An enclosed pellet or chip fuel heater with a fuel hopper and feed system. EPA lists free-standing, fireplace insert and built-in versions. |
| Fireplace | A wood-burning appliance intended mainly for looks, not as a space heater. A model line qualifies through one of three tests, covering the safety listing, the door and viewing area, or the way it is marketed. |
| Residential masonry heater | A wood-burning device in which heat from short, fast fires is stored in refractory mass and released slowly to the building. |
Section 60.531 also defines three appliances that subpart AAA exempts from its emission limits. A cook stove is a wood appliance made, marketed and warranted mainly for cooking, with an oven of at least 1 cubic foot. A camp stove is a portable stove with a pipe or chimney for a tent or temporary structure. A coal-only heater is marketed and warranted solely for coal.
The fireplace definition carries a rebuttal route. A model line positioned as aesthetic is presumed a fireplace. Test data showing average stack gas carbon dioxide of 5.00 percent or less, and a carbon dioxide to carbon monoxide ratio of 15:1 or more, can rebut that presumption.
Definitions in subpart QQQQ
Section 60.5473 defines a central heater as a wood or wood pellet burning device that warms spaces other than the one it stands in. The heat travels by air through ducts or by liquid through pipes. Forced-air furnaces and hydronic heaters are the two classes it lists, and EPA does not limit central heaters to those two.
| Class | EPA definition, restated |
|---|---|
| Residential hydronic heater | A wood or wood pellet burning device that heats building space, water or both by sending a heated fluid, usually water or a water and antifreeze mix, usually through pipes. |
| Residential forced-air furnace | A wood or wood pellet burning device that warms spaces other than its own by sending heated air through ducts. |
| Small residential forced-air furnace | A forced-air furnace with a maximum heat output below 65,000 BTU per hour. |
| Large residential forced-air furnace | A forced-air furnace capable of 65,000 BTU per hour or more. |
EPA's fact sheet on hydronic heaters describes them as also called outdoor wood boilers. They are usually outside the building they heat, in a small shed with a short smokestack. They heat water or a water and antifreeze mix that runs through pipes to homes, barns and greenhouses. Some sit indoors, and some burn corn or wood pellets.
The fact sheet on forced-air furnaces describes wood-burning warm air furnaces with a large firebox and a blower. They are usually indoors, with the stack or chimney on the roof of the building they heat.
What each class must certify
Subpart AAA, section 60.532, sets particulate matter limits for wood heaters. A weighted average of 4.5 g/hr applies from May 15, 2015. From May 15, 2020 the limit is a weighted average of 2.0 g/hr, or 2.5 g/hr under the cord wood alternative.
Subpart QQQQ, section 60.5474, sets limits per class. Hydronic heaters have a 2015 limit and a 2020 limit. Forced-air furnaces had work practice standards from May 15, 2015, then emission limits by size.
| Class | Start date | Limit |
|---|---|---|
| Hydronic heater | May 15, 2015 | Weighted average of 0.32 lb/mmBtu heat output, with a maximum of 18.0 g/hr for any individual burn rate |
| Hydronic heater, crib wood test | May 15, 2020 | 0.10 lb/mmBtu per burn rate |
| Hydronic heater, cord wood option | May 15, 2020 | 0.15 lb/mmBtu per burn rate |
| Small forced-air furnace | May 16, 2016 | Weighted average of 0.93 lb/mmBtu |
| Large forced-air furnace | May 15, 2017 | Weighted average of 0.93 lb/mmBtu |
| Small and large forced-air furnace | May 15, 2020 | 0.15 lb/mmBtu per burn rate, cord wood test |
Under the EPA fact sheets, each model line is certified by testing one representative appliance at an accredited laboratory. Certified heaters carry a permanent label. EPA says the hydronic rule does not require cord wood testing, so manufacturers test with cribs of lumber unless EPA approves a cord wood method. For forced-air furnaces EPA requires cord wood testing.
The fact sheets give EPA's sales estimates for 2015: nearly 14,000 hydronic heaters and nearly 28,000 forced-air furnaces. They add that the standards apply only to new heaters and do not affect heaters already in use.
Fuels named in the rules
Both subparts list prohibited fuels for affected heaters. The list includes garbage, yard waste, rubber, plastic, treated lumber, railroad ties, construction debris and unseasoned wood. The rules define unseasoned wood as wood with an average moisture content of 20 percent or more.
A heater certified for chip wood fuel may burn only chips that meet six minimums. Moisture is below 35 percent. Inorganic fines are 1 percent or less. Chlorides are 300 parts per million or less. Ash is no more than 2 percent, and trace metals are below 100 mg/kg. No demolition or construction waste is present. Pellet heaters may burn only pellets graded under a licensing agreement with a third-party organization approved by EPA.
Sources
- U.S. EPA via eCFR, 40 CFR Part 60 Subpart AAA, Standards of Performance for New Residential Wood Heaters, sections 60.530 to 60.532, current text, read October 16, 2026
- U.S. EPA via eCFR, 40 CFR Part 60 Subpart QQQQ, Residential Hydronic Heaters and Forced-Air Furnaces, sections 60.5472 to 60.5474, current text, read October 16, 2026
- U.S. EPA, Fact Sheet: Summary of Requirements for Wood-fired Hydronic Heaters, February 2015, read October 16, 2026
- U.S. EPA, Fact Sheet: Summary of Requirements for Wood-fired Forced Air Furnaces, February 2015, archived January 19, 2025 snapshot, read October 16, 2026