ArbNation Join free

Crane-assisted tree removal: OSHA Subpart CC, ASME B30.5 and B30.23, and LOLER

OSHA's crane standard excludes tree trimming and tree removal from its scope but holds a personnel hoisting section. ASME B30.5, ASME B30.23 and HSE's LOLER code each set their own scope.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page draws on OSHA, ASME and HSE publications. It is not training and does not teach the work. Licences for crane operators have their own guide.

OSHA Subpart CC: scope and the tree work exclusion

OSHA's cranes and derricks standard for construction, 29 CFR 1926 Subpart CC, applies to power-operated equipment used in construction that can hoist, lower and horizontally move a suspended load. Section 1926.1400(a) lists articulating cranes such as knuckle-boom cranes, crawler cranes, and mobile cranes such as truck-mounted and boom truck cranes. It also lists derricks, sideboom cranes and multi-purpose machines configured to hoist and lower a suspended load.

Paragraph 1926.1400(c) lists what the subpart does not cover. Item (13) reads "Tree trimming and tree removal work." The same list leaves out digger derricks used for pole work, vehicle-mounted aerial devices, machinery that hoists with a come-a-long or chainfall, and helicopter cranes. The full text is on OSHA's page for 1926.1400.

A separate paragraph in the same list, (c)(17), excludes articulating or knuckle-boom truck cranes delivering material to a construction site, with conditions. It is about material delivery and does not mention tree work.

Hoisting personnel under 1926.1431

Section 1926.1431 sits inside Subpart CC. Its paragraph (a) prohibits using equipment to hoist employees. The exception is where the employer demonstrates that conventional means would be more hazardous or are not possible because of structural design or worksite conditions. The section names a personnel hoist, ladder, stairway, aerial lift, scaffold and similar as conventional means.

When employees are hoisted, paragraph (b)(1) puts them in a personnel platform that meets the section's requirements. Hoisting without a platform is allowed only in listed cases, among them drill shafts, pile driving, marine transfer and storage-tank, shaft and chimney operations.

The section sets numbers for platform hoisting. The total load must not exceed 50 percent of the rated capacity for the radius and configuration. The platform itself must support its own weight and at least five times the maximum intended load. A trial lift with the unoccupied platform loaded at least to the anticipated lift weight is performed immediately before each shift in which personnel will be hoisted. The full text is on OSHA's page for 1926.1431.

Section 1926.1431 belongs to Subpart CC, and the scope paragraph of Subpart CC excludes tree trimming and tree removal work.

ASME B30.5, mobile and locomotive cranes

ASME sells the standard, and its product page lists B30.5 in a 2025 edition. Its scope covers crawler cranes, locomotive cranes, wheel-mounted cranes and variations that keep the same fundamental characteristics and use internal combustion engines or electric motors.

ASME excludes several types from that scope. They are side boom tractors, cranes for railway and automobile wreck clearance, and digger derricks. Cranes made for or used in energized electrical line service, knuckle boom cranes, trolley boom cranes and cranes rated at one ton or less are excluded too. ASME describes the standard as covering the construction, inspection, testing, maintenance and operation of mobile and locomotive cranes, and notes it is on stabilized maintenance.

ASME B30.23, personnel lifting systems

ASME lists B30.23 in a 2022 edition of 36 pages. It covers equipment used to lift, lower, hold or transport personnel in a platform, by wire rope or chain from hoist equipment, or on a platform mounted on the boom of the hoist equipment.

ASME's description adds that lifting personnel is not allowed using some B30 equipment. It directs readers to the B30 volume for the hoisting equipment in use to see whether B30.23 applies. This standard is also on stabilized maintenance.

Great Britain: LOLER and the L113 code

HSE's L113 is the Approved Code of Practice and guidance for the Lifting Operations and Lifting Equipment Regulations 1998 (LOLER). The second edition is dated December 2014, with amendments in 2018. HSE writes that LOLER applies to lifting equipment and builds on the Provision and Use of Work Equipment Regulations (PUWER).

The L113 page names the people the code is for: those who work with equipment provided at work, the employers of such people, those who represent them, and those who act as a competent person in examining lifting equipment. HSE says the second edition expanded its examples to show that LOLER applies across every sector using lifting equipment. HSE's page does not mention tree work.

Sources