Chainsaw exhaust and muffler: EPA and CARB emission rules, spark arrestor wording
EPA's Phase 2 rule for handheld engines named chainsaws in 2000. 40 CFR 1054.115 bars defeat devices on certified engines, and a maker's manual ties the muffler to a spark arresting screen and an emission warranty.
Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. Three official documents set the emission side: an EPA rule page, the federal rule text in 40 CFR 1054.115, and a California Air Resources Board (CARB) question-and-answer sheet. A maker's instruction manual for two chain saws supplies the muffler and spark arrestor wording.
EPA Phase 2 for handheld engines
EPA's page describes a final rule, published April 25, 2000, that sets a second phase of regulations for new nonroad spark-ignition handheld engines at or below 19 kilowatts (25 horsepower). The engines covered are used mainly in handheld lawn and garden equipment such as trimmers, leaf blowers and chainsaws. The standards phase in from the 2002 model year. The page cites 40 CFR Parts 90 and 91.
40 CFR 1054.115
Section 1054.115 lists requirements for engines that must meet the standards of part 1054. Its wording is addressed to the engine maker.
- Paragraph (b) requires engines with adjustable parameters to meet the part's requirements for any adjustment in the practically adjustable range.
- Paragraph (d) bars emission control devices or design elements that cause or contribute to an unreasonable risk to public health, welfare or safety while the engine operates.
- Paragraph (e) says the maker may not equip an engine with a defeat device. It defines one as an auxiliary emission control device that reduces the effectiveness of emission controls under conditions the engine may reasonably meet in normal operation and use.
The defeat device paragraph lists exceptions. They cover altitude kits, conditions largely covered by the test procedures, designs needed to prevent engine or equipment damage or accidents, and reduced effectiveness that applies only to starting.
CARB small off-road engine rules
CARB's January 2025 FAQ says its regulations apply to manufacturers, sellers, retailers and distributors of new spark-ignition engines of 25 horsepower or less, and require them to certify and label those engines. Chainsaws under 45 cc are on its list of covered equipment. CARB says full implementation begins with the 2026 model year.
The FAQ states that the regulations do not require owners or end users to stop using existing gas-powered tools. Landscapers and other users can keep using CARB-certified gas equipment for its full useful life, subject to any additional rules adopted by local governments.
Muffler wording in a maker's manual
The manual for two chain saws, document 0458-542-8621-D, treats the muffler under fire, hearing and emission headings.
| Topic | Wording |
|---|---|
| Modification | Any muffler modification could increase heat radiation, sparks or sound level, raising the risk of fire, burn injury or hearing loss, and may permanently damage the engine. Muffler service and repair are assigned to the servicing dealer. |
| Spark arresting screen | The muffler carries a screen meant to reduce the risk of fire from hot particles. The manual says never to run the unit with a missing or damaged screen. With a correct fuel mix the screen normally stays clean from the muffler's heat. |
| Laws | Some state or federal laws or regulations may require a properly maintained spark arrester for certain uses. In California, Public Resources Code sections 4442 and 4443 make it a violation to use gasoline-powered tools on forest-, brush- or grass-covered land unless the exhaust system has a complying spark arrester in effective working order. The manual says other states and agencies such as the U.S. Forest Service may have similar requirements. |
| Catalytic converter | Some saws have one in the muffler. The manual says that muffler cools more slowly than a conventional one after the engine returns to idle or stops. |
| Emission warranty | The manual's federal emission control warranty statement lists the muffler, and the catalytic converter where fitted, among the emission-related warranted parts. The statement says a part of equivalent performance and durability may be used in non-warranty maintenance or repairs, and that warranty coverage may be denied for unapproved modifications. |
| Compliance period | The Emission Compliance Period on the label gives the hours the engine was shown to meet federal requirements: A is 300 hours and B is 125 hours. |
Sources
- EPA, Final Rule for Phase 2 Emission Standards for New Nonroad Spark-Ignition Handheld Engines At or Below 19 Kilowatts (page last updated April 27, 2026), read October 21, 2026
- eCFR, 40 CFR 1054.115, What other requirements apply, read October 21, 2026
- California Air Resources Board, Small Off-Road Engine Regulations Frequently Asked Questions, January 2025, read October 21, 2026
- STIHL Incorporated, instruction manual for the MS 311 and MS 391, document 0458-542-8621-D, read October 21, 2026