ArbNation Join free

Hedge trimmer safety: IEC 60745-2-15 scope and two CPSC recall notices

IEC 60745-2-15 is the electric hedge trimmer standard, and its foreword names blade stopping time and blade controls. Two CPSC notices record a trigger that fails to spring back and a missing blade guard.

Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The facts come from the IEC standard's front matter, two recall notices from the US Consumer Product Safety Commission (CPSC) and the 2001 UK outdoor noise regulations. Clause text of the standard is not reproduced.

IEC 60745-2-15, scope and foreword

The standard is titled Hand-held motor-operated electric tools, Safety, Part 2-15: Particular requirements for hedge trimmers. The edition in the VDE Verlag preview is Edition 2.1, dated June 2009. It is a consolidated version that joins the second edition (2006) and amendment 1 (2009).

The scope applies to hedge trimmers made for one operator to trim hedges and bushes with one or more linear reciprocating cutter blades. It does not apply to hedge trimmers with a rotating blade. IEC subcommittee 61F prepared it, and it is used together with IEC 60745-1, the general part for hand-held motor-operated electric tools.

The foreword lists the main changes. Markings and instructions in clause 8 gained detailed safety warnings. Mechanical hazards in clause 19 gained requirements for handles, hand protection, the cutting device, blade stopping time, a lower barrier and a cutting device cover. For construction, clause 21 gained requirements for blade controls (switches) and for insulation of knobs and handles.

The 13-page preview has no blade brake or two-hand control wording. It names blade stopping time and blade controls only as subjects of clauses.

Two CPSC recall notices

CPSC hedge trimmer recall notices
NoticeCause classHazard, units and remedy
August 4, 2022, recall 22-197, Makita cordless hedge trimmers XHU07Z, XHU07T, XHU08Z and XHU08TMissing blade guardHazard: the protective guard on the shear blade is missing, with a risk of cuts.
Units: about 2,600.
Incidents: none reported.
Remedy: free repair with a prepaid return label and a new blade guard.
June 1, 2023, recall 23-212, EGO Power+ HT2410 cordless brushless hedge trimmers, date codes September 2017 through March 2019Control that fails to resetHazard: the rear switch trigger can fail to spring back after it is pressed, so the trimmer can start unexpectedly and cause lacerations.
Units: about 85,000 in the US and 4,000 in Canada.
Incidents: 34 US reports of unexpected starting, 8 lacerations that needed stitches.
Remedy: free repair of the rear trigger switch.

The Makita trimmers were sold from February to June 2022 for US$260 to US$420. The EGO trimmers were sold from September 2017 through March 2020 for US$150 to US$220. Other CPSC notices sit in the hedge trimmer recalls register.

Noise marking in the UK regulations

Hedge trimmers are in Schedule 2 of the Noise Emission in the Environment by Equipment for use Outdoors Regulations 2001, the list of equipment subject to noise marking only. Regulation 8(3) requires the guaranteed sound power level of that equipment to be marked on it. Schedule 4 defines the hedge trimmer, and Schedule 6 sets a noise test code for it.

ISO 10517, EN 62841-4-2 and OSHA are covered in the hedge trimmer safety guide.

Sources