ArbNation Join free

Machine types compared (no brands): chippers, grinders, loaders and trailers

Professional wood chippers, garden shredders, stump grinders, loaders and trailers each sit under a different published scope. HSE, CEN, ISO and NZTA give the dividing lines.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here.

The Health and Safety Executive groups the machinery used in forestry and arboriculture on one topic page: woodchippers, brushcutters, stump grinders, flails and mulchers. Chainsaws have separate guidance. HSE puts the duty in one line: no-one uses this equipment unless trained and competent to do so. Its tree work publications list leaflet AFAG606 for mobile stump grinders, and points to the Forestry Industry Safety Accord site for the Arboriculture and Forestry Advisory Group leaflets.

Comparison by type

Machine types and the published scope that separates them
TypeWhat the published text defines, and where
Professional wood chipperEN 13525:2020 covers self-propelled, mounted, semi-mounted and trailed chippers used in forestry, agriculture, horticulture and landscaping. They are manually loaded through a horizontal or near horizontal infeed chute and used when stationary. Source: CEN standard, Genorma catalogue entry.
Chipper outside that scopeEN 13525 leaves out vertical infeed chute chippers, machines only loaded mechanically, infeed chutes with a protruding extension table or conveyor, and shredders/chippers covered by EN 13683. Source: CEN standard, Genorma catalogue entry.
Garden shredder/chipperEN 13683 covers hand fed shredders/chippers with an integral power source, used outdoors in a stationary position by an operator standing on the ground. Each feed opening or segment fits into a 250 mm by 250 mm square. Source: Swedish Institute for Standards catalogue entry.
Mobile stump grinderHSE lists a leaflet for mobile stump grinders as AFAG606 and names stump grinders on its machinery topic page. Source: HSE.
Loader with quick couplerISO 13031:2016 specifies safety requirements for quick couplers used on earth-moving machinery as defined in ISO 6165. An amendment was published in 2025. Source: SNV catalogue entry.
Light trailerA trailer with a gross vehicle mass of 3500 kg or less. Source: NZTA Vehicle Inspection Portal.
Trailer in the UKMaximum authorised mass covers a vehicle or trailer including the maximum load it can carry on the road. Source: GOV.UK.

Chipper and shredder

EN 13525 and EN 13683 divide chippers by how they are fed, powered and moved. The 2020 edition of EN 13525 sits at the confirmed stage of the CEN life cycle, with the date December 4, 2025, and replaced EN 13525:2005+A2:2009. It does not cover national road rules for travel between work sites, or hazards from power take-off drive shafts.

The Swedish Institute for Standards lists the original SS-EN 13683 of 2003 as withdrawn and replaced by SS-EN 13683+A1:2009. EN 13683 leaves out units driven by an external power source and units with a powered feed intake. It also leaves out units with powered discharge meant to broadcast material or load vehicles.

Loader and trailer

For loaders, the published scope is the coupler between the machine and its attachment, in ISO 13031. For trailers, the plate figure is the dividing line: NZTA treats 3500 kg gross vehicle mass as the split between light and heavy, and GOV.UK uses maximum authorised mass for vehicles and trailers alike.

Sources