National Tree Climbing Guide chapter 2: job hazard analysis, required PPE and the two-climber team
Chapter 2 of the US Forest Service National Tree Climbing Guide (2015) lists six items in a job hazard analysis, seven items of required protective equipment and a basic team of two certified climbers.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
The named codes and training bodies are described here as published. It is not training and does not teach the work.
Section 2.1: job hazard analysis and communications
The US Forest Service National Tree Climbing Guide, 2015 electronic edition, opens its preparations chapter with a duty to prepare a job hazard analysis (JHA) for each assignment. Preparations also include getting any special training the assignment needs, discussing the best way to do the job with the team, and thoroughly rehearsing the climbing methods. The JHA has six items, in this order.
- Establish a check-out and check-in procedure.
- Analyze the assignment, then obtain the equipment needed.
- Inspect the equipment.
- Establish radio contact with the local Forest or District office or central dispatch from the climbing site. If direct radio contact is not possible, an alternative method of summoning emergency help is established before climbing.
- Assess the environment for potential hazards.
- Assess the tree and the immediate area for potential hazards.
Section 2.2: required personal protective equipment
The guide requires the following for all climbing assignments.
| No. | Item | Qualifier in the guide |
|---|---|---|
| 1 | Climbing harness | None |
| 2 | Climbing helmet | None |
| 3 | Long sleeved shirt and sturdy pants | None |
| 4 | Eye protection | None |
| 5 | Gloves | Recommended, not required, for general climbing; a must for any rappelling |
| 6 | Boots | Logger-style with lug soles are appropriate for most work; spur work calls for suitable heels and rigid arch supports |
| 7 | Hearing protection | For power tool use |
Section 2.3: working as a team
Two certified climbers make up the basic climbing team. One ground person can serve several climbers but must keep visual and unassisted natural voice contact with all of them. Both team climbers may climb at the same time if both have quick descent capability and stay within voice contact.
- All team climbers shall be qualified to perform every aspect of the assignment so that a rescue is possible.
- All team climbers shall have current medical training equal to at least a basic American Red Cross first-aid course.
- The team shall establish radio contact with the Forest or District office or central dispatch before climbing, and a sign-out system is in effect.
- Team members shall check each other's equipment before climbing.
- The ground person shall not be directly under the climber unless the climber has cleared it. The climber stays in an "at rest" position until the ground person leaves.
Section 2.4: hazard assessment
The guide groups hazards as environmental and tree hazards and states "no tree is worth a human life". It lists five conditions under which a tree is not climbed unless the JHA mitigates them:
- wind speed over 25 mph, or gusts;
- less than full daylight;
- air temperature low enough to create an unsafe condition;
- a lightning storm close by;
- a power line close enough for the climber, equipment or branches to contact it. The guide bars climbing any tree closer than 10 feet from energized conductors unless the climber is qualified as a line clearance arborist.
For tree hazards, both team members walk around the tree and assess it before the climb.
How OSHA words the PPE assessment
OSHA 1910.132(d) requires the employer to assess the workplace for hazards that call for PPE. The employer selects PPE that protects against the hazards found, has each affected employee use it, tells employees what was chosen, and selects PPE that fits. A written certification names the workplace evaluated, the person certifying, the dates, and identifies itself as a certification of hazard assessment. Paragraph (e) bars defective or damaged PPE. Paragraph (h)(1) has the employer provide required PPE at no cost, with listed exceptions.
How Great Britain words the planning duty
Regulation 4 of the Work at Height Regulations 2005 requires every employer to see that work at height is properly planned, appropriately supervised and carried out as safely as is reasonably practicable. The planning includes selecting work equipment and covers emergencies and rescue. Work at height is carried out only when the weather does not jeopardise health or safety. The Health and Safety Executive (HSE) step-by-step guide sets a sequence of questions: can the work avoid height, can a fall be prevented, can the distance and consequences of a fall be minimised. It gives doing as much work as possible from the ground, with extendable tools, as its first example, and puts collective protection before personal protection.
The whole guide is outlined in the guide to the National Tree Climbing Guide. Its rescue chapter has a page of its own.
Sources
- US Forest Service, National Tree Climbing Guide, 2015 electronic edition, chapter 2, read October 19, 2026
- OSHA, 29 CFR 1910.132 General requirements (personal protective equipment), read October 19, 2026
- legislation.gov.uk, The Work at Height Regulations 2005, regulation 4, read October 19, 2026
- HSE, Work at height step-by-step guide, read October 19, 2026