ArbNation Join free

No-dig construction near trees: cellular confinement and porous surfacing as the guidance describes them

No-dig surfacing puts a stone-filled geocell mat on the ground above tree roots instead of digging out a sub-base. Arboricultural Association Guidance Note 12 sets out the surfaces, the 20 percent figure from BS 5837 and the limits of the method.

Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.

The named guidance note, standard and maker leaflet are described here as published. It is not training and does not teach the work.

Why digging is the problem

Arboricultural Association Guidance Note 12 (September 2020) starts from standard road practice. Builders strip the upper soil and lay a compacted sub-base under a durable wearing course. That method can sever shallow roots, and the compaction can limit later root growth. The note adds that vehicles on unreinforced ground are particularly damaging to soil structure, though repeated foot traffic can also harm it.

The note places most of a tree's fine roots in the upper 30 cm of soil. In deep, well-aerated soils it puts almost all woody roots in the upper 60 cm, with some reaching 2 to 3 m. A geosynthetics maker's leaflet of June 2006 gives a different cut: 80 to 90 percent of a tree's roots in the upper metre, with few below 2 to 3 m.

The cellular confinement system

Guidance Note 12 describes a geocell as a honeycomb mat of high-density polyethylene strips, ultrasonically bonded. The mat lies on a non-woven geotextile on the ground surface. It is filled with clean angular stone and topped with a wearing course. The note says this approach has been used in the UK for over 20 years.

The note names several parts of the specification. Cell walls are textured for friction with the stone. Seam strength is critical to durability, and products should conform to ISO 13426-1:2003. Cells made of flexible geotextile are called unsuitable near trees in most cases because they deform as they fill. A geogrid alone is not recommended, though one can lie beneath a geocell mat as a separation layer.

The note says an arboriculturist can prescribe the basic approach, but the final specification should come from or be approved by a civil engineer. Standard geocell depths assume a subgrade California Bearing Ratio (CBR) of at least 3. On softer ground the note calls for an engineer to decide whether an extra sub-base is needed. Unless the ground is particularly soft, a stone-filled geocell sub-base up to 2 m deep can carry refuse trucks or fire engines without compacting the soil beneath.

Surfaces over the geocells

The note says permeable surfaces let gases, water and heat pass between soil and air. In most cases it calls standard tarmac inappropriate above root zones because it seals the soil. It allows for exceptional cases where a sealed surface over a geocell is the only way to avoid a standard foundation, with the arboriculturist weighing the whole impact on the trees.

Surface options in Guidance Note 12
SurfaceWhat the note records
Porous asphaltOpen-graded aggregate bound with asphalt cement. Called probably the best surface over geocells because it tends not to crack or form potholes. Standard mixes suit cycle paths and footpaths. Car parks and driveways need stronger binders.
Loose gravelSuits light, slow residential traffic. Turning vehicles disturb it and the camber must hold it. Small plastic stabilisation grids can retain gravel or soil above a geocell sub-base.
Resin-bound gravelPermeable and stable under heavy traffic. The layer is thin, 18 to 25 mm, and lies on a porous asphalt base 80 to 150 mm deep.
Permeable block pavingHighly permeable and able to bear heavy traffic. The blocks need a bed of sand or fine chippings, so a second geotextile sits above the infill.

The note says all permeable surfaces are likely to need maintenance to prevent clogging, and puts cleaning at about once a year, more often under trees that drop blossom or fruit. It adds that uncapped geocells need an annual check, because the polyethylene can degrade in sunlight.

Limits the guidance names

BS 5837:2012 recommends that new permanent hard surfacing not exceed 20 percent of the unsurfaced ground in a tree's root protection area. Guidance Note 12 calls that a cautious figure, not necessarily an absolute limit. The note defines the root protection area as usually a radial distance of 12 times the trunk diameter at 1.5 m. For veteran trees it gives a buffer of at least 15 times the trunk diameter, or 5 m from the canopy edge if larger. For ancient woodland it gives at least 15 m.

The note concludes that installing a geocell surface will inevitably have a small adverse impact on the health of affected trees. It reports that healthy trees usually stay healthy under a permeable surface on a geocell sub-base. Few long-term studies exist on soil and tree health under geocells.

Other limits in the note:

  • Underground services should not run beneath a geocell system, because later repairs could compromise it.
  • Ramping up from an existing road can need some digging in the root protection area. The note says a geocell may then be an inappropriate solution.
  • Geocells have a design life of 120 years if shielded from sunlight. Permeable paving has about 20 years, so the wearing course is usually replaced first.
  • Piled rafts and stone-filled gabions are named as alternatives. The note treats any bridging of root zones as acceptable only where encroachment cannot be avoided.

Method statements and supervision

The note's key recommendations tie installation to a project-specific arboricultural method statement. They put the levelling of ground before the geocells under arboricultural supervision and say local authorities should condition that supervision and ask for records of visits. A tracked excavator in a root protection area is permitted only under a suitably qualified arboriculturist.

BS 5837 and the earlier practice notes

BSI lists BS 5837:2012, Trees in relation to design, demolition and construction, as published on 30 April 2012. It supersedes the 2005 edition. BSI says its recommendations apply whether or not planning permission is required.

The maker's 2006 leaflet traces the idea to Arboricultural Practice Note 1, Driveways Close to Trees (1996). That note allowed driveways inside the root protection area if four conditions held. Roots are not severed, soil is not compacted, oxygen and carbon dioxide move freely, and water infiltration is not impeded. The leaflet cites the 2005 edition of BS 5837 and repeats the 20 percent figure. Guidance Note 12 names Arboricultural Practice Note 12 (2007) as the guidance it updates.

Related pages cover ground protection over roots during works and paving near tree roots.

Sources