Satellite, aerial and LiDAR detection of vegetation encroachment on power lines
Hydro Ottawa reports tree-contact outages down 44 percent since adding satellite imagery and post-storm trimming. A Slovenian paper measured a 19 cm average error from helicopter LiDAR, and a 2023 review compares satellite, aircraft and drone methods.
Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.
Three sources cover how utilities find trees growing into power lines from above: a utility's own programme page, a peer-reviewed paper on aircraft LiDAR, and a literature review in Arboriculture & Urban Forestry. Each reports its own results, on its own corridor and with its own data. Wider background on lidar, drones and remote sensing in utility work is on lidar, drones and remote sensing in vegetation management.
Hydro Ottawa's satellite programme
Hydro Ottawa serves a territory of 1,100 square kilometres and has a tree trimming programme that covers 60,000 trees a year. Tree contact still ranks among the leading causes of outages in bad weather, the utility reports. In 2022 it partnered with an AI vegetation software company, days before the May 2022 derecho brought winds of up to 190 km/h to Ottawa.
The system scans the grid twice a year. It analyses chlorophyll levels in high-resolution satellite and aerial images, including near-infrared and shortwave infrared bands. Machine learning models then assess vegetation health, mark high-risk zones and flag declining trees before visible signs of decay. Local data on equipment, risks and terrain go into the maps of vegetation near lines and circuits. Hydro Ottawa describes the shift as one from a fixed trimming schedule to a risk-based approach.
| Measure | Reported change |
|---|---|
| Outages caused by tree contact, 2024 against the two-year average before the May 2022 derecho | Down 44 percent |
| High-priority spans, year over year | Down 18 percent |
| Medium-priority spans, year over year | Down 14 percent |
| Clear-spans with no apparent vegetation risk | Up 27 percent |
The utility counts spans as high priority where encroaching vegetation posed a significant threat, and it credits the technology together with post-derecho trimming for the drop in outages. The blog post, dated August 21, 2025, gives no detection error rates.
Helicopter LiDAR on a Slovenian transmission corridor
Mongus and colleagues at the University of Maribor and the transmission company ELES published their results in Remote Sensing in December 2021. The study corridor ran 18 km from Nova Gorica to Avče and held 104 power cables spanning about 168 km. LiDAR was flown from a helicopter in 2014 and 2018, and the data were processed at 0.5 m resolution.
The abstract reports an RMSE of about 1 m for tree growth simulation and a 0.37 m error in encroaching vegetation detection. The paper's own check on five individual trees found an average absolute clearance error of 19 cm and a maximum of 37 cm. A related drone LiDAR study reached better accuracy, the authors report, and they trace the gap to the helicopter flying higher and recording lower point density.
Against field records, 10 corridor clearances done from 2014 to 2017 covered about 1.9 km2. The method flagged 132 areas of encroaching vegetation inside them, about 0.5 km2 in total. Clearance crews had cut the whole inner corridor rather than only the flagged vegetation, which the authors give as the reason the flagged area is smaller.
Outside the cleared areas the method flagged 449 further regions, 1.8 km2 in all. Of these, 396 were under 10 m2 and fit single branches or clusters rather than trees. Of the 53 larger regions, 34 sat on forest edges, where a single branch posed the threat although the tree-top had not been flagged. The authors attribute part of the over-detection to field threat assessment, which they call prone to error. They report about 10 minutes of processing for threat assessment over 24 km2 at 0.5 m resolution.
What the review compares
Walker and Dahle reviewed unmanned aircraft and LiDAR for distribution utility vegetation management in Arboriculture & Urban Forestry 49(3), May 2023. They group remote sensing of utility corridors into 2D image-based and 3D point-based methods, and set the stakes in US$2 to US$10 billion of annual vegetation management costs for utilities in the United States.
- Satellite imagery. It lacks the resolution to give specific terrain and vegetation information in or near the corridor, the review reports, citing a 2020 study.
- Aerial imagery. Techniques depend on manual stereo measurements.
- Drone imagery. Optical imaging and radiometric normalization remain hurdles.
- Aerial LiDAR. It is popular in power-line corridor studies. Systems are carried on small aircraft such as helicopters and airplanes at relatively high operating cost. An older case study found LiDAR scanning completed 50 km a day, the equivalent of four days of visual inspection.
- Drone LiDAR. Falling LiDAR costs and affordable drones make it a possible next step. The review finds a research gap for distribution-level use.
The review also reports that foot patrol for visual inspection depends on an individual forester's subjective reading, so results may differ between inspectors. An early forest inventory study cited in it detected 72 percent of dominant trees and 51 percent of all trees from LiDAR. Trees outside the right-of-way are often not inspected, and the review points to drone LiDAR as a way to find risk trees there.
Sources
- Hydro Ottawa, Ottawa's high tech urban forest, blog post dated August 21, 2025, read October 21, 2026
- Mongus et al., A Complete Environmental Intelligence System for LiDAR-Based Vegetation Management in Power-Line Corridors, Remote Sensing 13(24), 5159, December 20, 2021, read October 21, 2026
- Walker and Dahle, Literature Review of Unmanned Aerial Systems and LIDAR with Application to Distribution Utility Vegetation Management, Arboriculture & Urban Forestry 49(3): 144-156, May 2023, read October 21, 2026