ArbNation Join free

Trailer hookups and breakaway chains: FMCSA and DVSA

Federal rules in 49 CFR Part 393 set the tow-bar lock, the safety chain strength and the 15 minute breakaway brake hold. The UK's DVSA lists breakaway cable checks for car-towed trailers.

Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The United States text is 49 CFR Part 393, the Federal Motor Carrier Safety Administration's parts and accessories rules, taken from the eCFR. The British text is DVSA guidance on GOV.UK.

Coupling and tow-bar rules in 49 CFR 393.70

Section 393.70 covers coupling devices and towing methods outside driveaway-towaway operations. It opens with a tracking test. Towed vehicles must not deviate more than 3 inches to either side of the path of the towing vehicle on a level, smooth, paved surface.

A full trailer needs a tow-bar and a way to attach it to both vehicles. The section lists four conditions for the tow-bar and its mounting:

  • It is structurally adequate for the weight being drawn.
  • It is properly and securely mounted.
  • It allows adequate articulation at the connection without excessive slack.
  • It has a locking device that prevents accidental separation of the towed and towing vehicles.

The hitch mount on the towing vehicle must include frame reinforcement or bracing sufficient to prevent undue distortion of the frame. Fifth wheel assemblies get their own paragraph, with a locking mechanism that prevents separation unless a positive manual release is activated.

Safety chains and cables

Paragraph (d) of section 393.70 applies to every full trailer and every converter dolly. Each must be coupled to the frame, or an extension of the frame, of the towing vehicle with one or more safety devices. The aim stated in the text is to stop the towed vehicle breaking loose if the tow-bar fails or comes disconnected.

Safety device requirements, 49 CFR 393.70(d)
ItemWhat the text sets
Attachment pointNot on the pintle hook or any other device that holds the tow-bar. An exception covers pintle hooks made before July 1, 1973, at a place independent of the hook
SlackNo more than is necessary to turn the vehicles properly
StrengthThe device and its attachments must have an ultimate strength of not less than the gross weight of the vehicle or vehicles being towed
Tow-bar dropConnected so the tow-bar cannot drop to the ground if it fails or disconnects
Number of chainsTwo safety chains or cables, or one bridle arrangement attached to the frame or axle at two points as far apart as the frame or axle allows
Single cableNeeds a thimble and twin-base cable clamps to form the forward bridle eye
Towing vehicle attachmentTwo points equally distant from, and on opposite sides of, the centerline. A shared point, bridle or single device sits on the centerline or within 152 mm (6 inches) to the right of it
Other devicesMust match chains or cables on strength, security of attachment and directional stability

A converter dolly with a solid tongue and no hinged tow-bar is treated differently. It may use two chains or one chain used alone, and a single device must run in line with the centerline of the tongue.

Breakaway braking in 49 CFR 393.43

Section 393.43 puts duties on both vehicles. A motor vehicle that tows a braked trailer needs a means so that, after a breakaway, its service brakes can still stop it. For air brakes, the tractor protection valve operates automatically between 138 kPa and 310 kPa (20 psi and 45 psi).

For the trailer, paragraph (d) says every trailer required to have brakes must have brakes that apply automatically and immediately on breakaway. Trailers with three or more axles are excepted from the rule that all required brakes apply. The brakes must stay applied for at least 15 minutes. Driveaway-towaway operations are exempt from paragraphs (b), (c) and (d).

Section 393.71 is the parallel text for driveaway-towaway operations. It limits a combination to three saddle-mounts and one tow-bar or ball-and-socket coupling. It also requires at least two safety chains or cables when chains are the safety device.

DVSA checks for car-towed trailers

The Driver and Vehicle Standards Agency publishes safety checks for towing a trailer, caravan or horsebox with a car in England, Scotland and Wales. The page was published on November 26, 2016 and last updated on April 22, 2024.

  • Tow ball and connections: correct coupling to the towball or pin, correct coupling height, and an undamaged 7 or 13 core cable and plug.
  • Breakaway cable: a breakaway cable or secondary coupling engages the trailer's brakes, if fitted, or stops the trailer if it comes off the car.
  • Cable condition: not worn or damaged, with enough slack that it does not apply the brakes unintentionally and does not drag on the ground.
  • Weight: a trailer with no braking system must not weigh over 750 kg loaded, and should not weigh more than 50 percent of the car's weight.

DVSA states that a fine of up to GBP 2,500, a driving ban and 3 penalty points can follow for using a vehicle in a dangerous condition. For a braked trailer, the car and loaded trailer must not weigh over the second weight on the car maker's plate.

Sources