ArbNation Join free

Tree protection zones by city: Portland, Toronto, Spokane and San Mateo

Portland and Spokane set the zone at one foot of radius per inch of trunk diameter. San Mateo uses ten times the diameter, and Toronto prints a table of metres by trunk size.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here.

Four cities compared

CityZone distanceTrunk measured at
Portland1 foot of radius per inch of diameter, from the face of the trunkDefined in section 11.80.020 C, which the zone rule cites
Toronto1.2 m to 6.0 m for city-owned and private trees, by trunk size1.4 m above the ground
Spokane1 foot of radius per inch of diameter, for trees in the right of way4.5 feet above grade
San Mateo10 times the trunk diameter, or as the project arborist specifies and the City Arborist approves54 inches above grade

Portland

Portland City Code section 11.60.030, effective January 1, 2025, calls the area a root protection zone. On the prescriptive path it is a minimum radius of one foot, measured horizontally from the face of the trunk, for each inch of tree diameter. For street trees the City Administrator may prescribe more or less protection than for trees on the development site. The Portland Permitting and Development page gives an example: a 12-inch tree has a 12-foot radius. That page measures the radius from the center of the trunk, where the code measures from the face of the trunk.

The code allows existing structures, paved surfaces and utilities inside the zone to stay. New encroachments are allowed if their total area is under 25 percent of the remaining zone area, and none comes closer than half the required radius. Fencing is a minimum six-foot chain link fence on eight-foot metal posts at the edge of the zone and of the permitted encroachment area. Existing structures or secured fencing at least 3.5 feet tall can serve as the fence. A sign on each fence names the zone and the penalties.

Inside the zone the code prohibits ground disturbance, vehicle or equipment access (other than on existing streets or driveways), storage of equipment or materials, stockpiling, new buildings, impervious surfaces, underground utilities, excavation, fill and trenching. The fence goes up before any ground disturbing work and stays until final inspection. The Portland page adds in-ground irrigation to the prohibited list and describes roots over 4 inches in diameter as the structural roots that support the tree.

Where the prescriptive path cannot be met, the performance path lets an arborist prepare an alternative root protection zone. The arborist visits the site, examines the tree's size, location and root cover, and signs a plan with the rationale. The City Administrator may require peer review, reject the plan, or require a performance guarantee.

Toronto

Toronto's Tree Protection By-law Declaration, form 01-0348 dated November 2021, prints minimum protection distances for chapter 813, Trees, and chapter 658, Ravine and Natural Feature Protection. Distances are measured from the outside edge of the tree base. Trunk diameter is measured at 1.4 m above the ground. The form says Urban Forestry may require a larger zone for some trees, depending on site conditions.

Trunk diameterCity-owned and private treesRavine and natural feature trees
Under 10 cm1.2 m1.2 m
10 to 29 cm1.8 m3.6 m
30 to 40 cm2.4 m4.8 m
41 to 50 cm3.0 m6.0 m
51 to 60 cm3.6 m7.2 m
61 to 70 cm4.2 m8.4 m
71 to 80 cm4.8 m9.6 m
81 to 90 cm5.4 m10.8 m
91 to 100 cm6.0 m12.0 m

The form lists three triggers for a permit to injure or remove a tree. One is construction activity inside the zone of a protected tree. Another is removal of a protected tree because of construction. The third is fill or a grade change inside a zone or a ravine and natural feature protected area. Protected private trees are those 30 cm or more in diameter at 1.4 m, plus replacement trees of any size. Trees of all sizes on the City road allowance are protected. A building permit does not give permission to injure or remove a protected tree.

Spokane

Spokane's Urban Forestry document on tree protection specifications for development applies to trees in the public right of way. It sets the minimum zone equal to the critical root zone as the International Society of Arboriculture defines it: a 1 foot radius from the base of the trunk for each inch of trunk diameter at 4.5 feet above grade. Urban Forestry staff set the zone in the field, or the contracted arborist sets it for staff approval. Changes are made only with prior authorization.

The document specifies temporary orange plastic construction fencing at least 3 feet tall, outside the zone. It lists no storage of construction materials, debris or excavated material in the zone, and no vehicles or foot traffic there.

San Mateo

San Mateo's tree protection standard details cite chapter 13.40 of the Municipal Code. They define the zone as the area around a tree with a radius of 10 times the trunk diameter, measured at 54 inches above grade. A project arborist may specify otherwise, with the City Arborist's approval. Construction activities as defined by the code are not allowed inside it. Protected trees include oaks with a trunk diameter of 10 inches or more, other species at 15 inches or more, and all trees in the public right of way. The details show a six-foot chain link fence on iron posts driven at least two feet into the ground, no more than ten feet apart, enclosing the zone.

A 12-inch trunk gives a 12-foot radius in Portland and Spokane, and a 120-inch radius, or 10 feet, in San Mateo.

Sources