ArbNation Join free

Tree work safety in Germany: the SVLFG accident prevention rules and brochure on tree work

Germany's farm, forestry and garden insurer SVLFG sets tree work rules in VSG 4.2, edition September 30, 2021. Its brochure B08 explains them. The rules fix a fall zone, a 3 metre fall-protection height and rest times.

Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.

The Sozialversicherung für Landwirtschaft, Forsten und Gartenbau (SVLFG) is the statutory accident insurer for agriculture, forestry and horticulture. It labels its accident prevention rules VSG. The earlier rule that VSG 4.2 replaced was labelled UVV 4.2. Rule VSG 4.2, Gartenbau, Obstbau und Parkanlagen, has been in force since January 1, 2000, and the edition on the SVLFG site is dated September 30, 2021. The named codes and training bodies are described here as published. It is not training and does not teach the work.

Who counts as doing dangerous tree work

Section 2 of VSG 4.2 allows an employer to assign dangerous tree work only to people who are expert (fachkundig) and medically found free of physical or mental defects that endanger them or others. The notes give these as examples of dangerous tree work:

  • climbing trees, including work in the crown with access technique;
  • felling woody plants over 20 cm at breast height, measured 1.30 m above ground;
  • work with chainsaws;
  • processing windthrow and wind or snow breakage.

Fruit harvest, fruit tree care and training cuts in nurseries are not tree work in this sense. The SVLFG tree work page adds that people under 18 may do dangerous tree work only as far as their training aim requires and under an expert's guidance and supervision.

Section 3: carrying out tree work

VSG 4.2, section 3, closely restated
ParagraphContent
(1)The employer must see that tree work is done under an expert's direction, with regard to local conditions
(2)Work needs enough visibility. Climbing trees is not permitted in hazardous weather; the notes name rain, fog, snow showers, ice and snow, thunderstorms and strong wind
(3)Care and sawing work on the standing trunk and in the crown is done only from safe standing places, with fall protection at standing places above 3 m
(4)Only the people doing the cut stay in the fall zone of trunk parts and branches
(5)In a work basket with a chainsaw, only the person doing the sawing is in the basket, unless special measures keep a second person out of the saw's danger zone
(6)Near overhead lines, a safety distance that depends on the nominal voltage is kept, also for work equipment

The notes define the fall zone as a circle around the point below the cut, with a radius of twice the length of the trunk part or branch and at least 6 m. For chainsaws, they give as examples of safe standing places the ground where there is no slip risk, MEWPs, work baskets and platforms, and sound branches reached with tested rope techniques (SKT B). Ladders and branches reached with technique SKT A are also given as examples for tools that are not motor-driven. Section 8 names the breaches that are administrative offences under section 209 of Social Code VII: section 2 sentence 1, and section 3 paragraphs 1, 4, 5 sentence 1 and 3 sentence 2.

Rope-supported work in the crown

Annex 1 of VSG 4.2 covers rope-supported work where MEWPs or work baskets cannot suitably be used. It rests on a written, site-specific risk assessment. Rope-supported crown work is done by at least two people who:

  • hold proof of training in rope-supported techniques;
  • are fully equipped for them;
  • are trained first aiders;
  • carry out rescue drills at least once a year, with written proof;
  • stay within call and sight of each other.

Annex 1 also sets a second trained climber with equipment, including a cutting tool, as the rescuer, and a first aid kit to DIN 13169. It says the climber should take 15 minutes of rest after two hours of work in the standing tree and 30 minutes after a further two hours. Rope-supported work in the standing tree is to end after six hours. Climbing gear gets an expert check at least once a year. Annex 2 sets a five-day, 40-hour course, with no more than five participants per trainer, for the SKT A qualification.

Power line distances

Safety distances in VSG 4.2 annex 1 and brochure B08
Nominal voltageDistance
Up to 1,000 V1.0 m
Over 1 kV to 110 kV3.0 m
Over 110 kV to 220 kV4.0 m
Over 220 kV to 380 kV, or voltage unknown5.0 m

The B08 brochure

SVLFG brochure B08, Baumarbeiten, runs to 76 pages. It covers expertise, protective equipment, chainsaws, felling, processing wood, pruning, MEWPs, ladders, chippers, stump grinders and securing the work area. It also holds framework curricula, operating-instruction templates and a site-specific risk assessment form. Its felling pages repeat the danger zone as a circle of twice the tree height. The ladder pages say chainsaw use from a ladder is forbidden in every case. For MEWPs, the brochure says they stand only on ground of enough bearing capacity, after the permitted ground pressure is worked out, always on load-spreading plates of sufficient size.

Sources